HANG SUPPORT ASSEMBLY ON
REAR DRAWBAR (See Fig. 1)
1.Slide flanges of support assembly into drawbar slots first, then, pivot backwards inserting pin into drawbar pin hole.
2.Be sure support assembly is seated properly, then secure with retainer spring,
SUPPORT
ASSEMBLY
DRAWBAR SLOTS
"A" shown)
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
| 03128 |
DRAWBAR | RETAINER |
PIN HOLE | |
FIG. 1 | SPRING |
MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting cover assembly to tractor.
1.Lift cover and align cover brackets with support assembly tubes.
2.Slide cover assembly down onto the support tubes.
\
SUPPORT
ASSEMBLY
COVER
ASSEMBLY
03024
FIG. 2
5