3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE QRDER -
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
Weak or Dead Fully Charged
BatteryBattery
REPLACING BATTERY
_I=WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift seat pan to raised position.
2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in same position as old battery.
4.First connect RED battery cable to positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5.Connect BLACK grounding cable to negative
Seat Pan
Terminal
Hex
Bolt
Positiv_
(Red) Cable
Negative (Black) Cable
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the gdU.
4.Close hood,
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Headlight Wire
Connector
26