Ch 1-5 Unbalanced Inputs

CONNECTING A SURROUND CONTROLLER TO THE UNBALANCED INPUTS ON YOUR A 52

Use these inputs if your surround controller doesn’t have balanced output connectors or if you simply prefer to use unbalanced connections.

RCA Plugs

What You’ll Need:

•Five shielded interconnect cables with RCA plugs

•A surround controller with five RCA output jacks

Before Connecting

❑Leave the AC cord on the A 52 disconnected until you have made all other connections to prevent any surprise burst of sound.

❑Make sure that all your cables are long enough so they are not pulled or stretched once they are connected.

❑Make sure the Balanced-Unbalanced Inputs selector switch on the A 52 is in its Unbalanced (lower) position and the Ground switch is in its Normal (lower) position.

To Connect

1Plug one end of the cable into the Unbalanced Ch 1 Input jack on the A 52.

2Plug the other end of the cable into the unbalanced output jack for the channel on your surround controller that you wish to correspond to Ch 1 on your A 52.

3 – 0 Repeat steps 1 and 2 for Ch 2, Ch 3, Ch 4, and Ch 5.

		OUTPUTS
2	4	6	8	10

SURROUNDŁ CONTROLLER

Inputs Switch,

set to down position

Ground Switch,

set to down position

Parasound Products, Inc.

San Francisco, CA USA

L U C A S F I L M

Manufactured under license from Lucasfilm Ltd. Lucasfilm and THX are registered Trademarks of Lucasfilm Ltd.

CAUTION

To Prevent Electric Shock, Do Not

Remove Cover. No User-Serviceable

Parts Inside, Refer Servicing To

Qualified Service Personnel.

Ch 1	Ch 2	Ch 3	Ch 4	Ch 5
Balanced	Balanced	Balanced	Balanced	Balanced

Input

Unbalanced

Balanced		Audio	Sensitivity	Lift
			50 mV 250
		Man
Unbalanced Output	Input	12 V		Normal
Inputs				Ground
	Auto Turn On
		WARNING
	To Prevent Fire Or Shock Hazard,
	Do Not Expose This Unit To Rain
		Or Moisture.
		Fuse
	T15A/250V1-115V Area
		T8A/250V-230V Area
		AC 115V	60Hz
		AC 230V	50Hz

Power Consumption: 1350W

YOU SHOULD KNOW

Write Down Your Connections

Make a note of which channel on your surround controller now connects to each channel of the A 52 so you’ll always hear the channels in their intended position and to facilitate trouble-shooting in case you encounter a problem later on.