Craftsman 917.27621 manual Fuel System, Engine OIL, Cylinders, Other

Page 29

Immediately prepare your tractor for stor- age at the end of the season or if the trac-

_91_,wAWillnot be used for 30 days or more. RNING: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see "TO

CLEAN BATTERY AND TERMINALS" in the Maintenance section of this manual).

After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture

which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carbure- tor. Do not empty the gas tank and carbu- retor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark

plug hole(s)into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable pro- tective cover that does not retain mois-

ture. Do not use plastic. Plastic cannot

breathe which allows condensation to

form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

29

Image 29
Contents Criiftsmiih Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentGeneral Operation II1. Children ServiceIV, Towing Safe Handling of GasolineGeneral Service Congratulations Sears Installation ServiceCustomer Responsibilities AgreementsJJJ Steering WheelCheck Battery Tools Required for AssemblyUnpack Carton Before Removing Tractor from Skid Attach Steering WheelInstall Seat Install Mower and Drive Belt Connect Rear PinsAssemble Gauge Wheels to Mower Deck Attach Front PlateALL Belts ForPosition Property damage Tractor Stopping HOW USE Your TractorTo SET Parking Brake To Stop Mower Blades To Adjust Mower Cutting HeightTo Operate Mower Towing Carts and Other ATTACH- Ments To TransportBefore Starting the Engine Check Engine OIL Level ADD GasolineMowing Tips To Start EngineGeneral Recommendations Lubrication ChartOperator Presence System Reverse Operation System ROS TiresBlade Care Blade RemovalChecktransaxle OIL Level BatteryClean AIR INTAKE/COOLING Areas Clean AIR ScreenMuffler Spark PlugsTo Remove Mower To Install MowerSIDE-TO-SIDE Adjustment To Level Mower HousingBoth Front Plate Links Must be Equal in LengthMower Drive Belt Removal Mower Drive Belt InstallationTo Replace Mower Drive Belt To Replace Motion Drive Belt To Adjust Attachment ClutchTo Check and Adjust Brake Replacing Battery To Adjust Steering Wheel Align MentTo Start Engine with a Weak BAT Tery To Remove Wheel for RepairsTo Remove Hood and Grill AS- Sembly To Replace Headlight BulbTo Adjust Carburetor Engine OIL Fuel SystemCylinders OtherStart Engine ProblemCause Correction ProblemOFF Problem Cause CorrectionTractor - Model Number 917,276210 SchematicTractor - Model Number Electrical Electrical Tractor - Model NumberTractor - Model Number 917,276210 Chassis and Enclosures Part Description Tractor - Model Number 917,276210 Ground Drive KEY Part Description Tractor - Model Number 917,276210 Steering Assembly KEY Part NO. no DescriptionSpark Arrester KIT EngineKEY Part Tractor - Model Number 917,276210 Seat Assembly Wheels Tires DecalsKEY Part Lift AssemblyAcop v,.,v 110485X Tractor - Model Number Mower DeckTransaxle Dimensions Given U.S. inches 44!1! jl Carburetor Gasket SET 69P 690231 499585 KEY Part Description Briggs & Stratton ENGINE-MODELOnly Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationOur Home