TO ASSEMBLE GRASS CATCHER
1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.
2.Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Frame
VinylFrame
bindingsopening
TO PREPARE BATTERY
NOTE: Your battery must be charged before you can start your lawn mower.
1.Open battery box.
2.Connect battery charger connector (male) to harness connector (female).
3.Plug battery charger into 110 volt A.C. outlet.
4.Leave battery charger connected for
24 hours before starting your engine for the first time.
5.After charging, disconnect harness connector (female) from battery char-
ger connector (male).
Connect your battery charger to charge battery as required.
IMPORTANT: The engine will not re- charge your battery.
At the end of the mowing season the battery should be charged for 48 hours to
,_otect the battery during winter storage. CAUTION: Always disconnect the harness connector to prevent accidental starting when transporting or storing your
lawn mower after the season.
Battery
Harness connector (female)
ger
connector (male)
Battery box
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a mulcher. To convert mower to
bagging or discharging, see "TO CON- VERT MOWER" in the Operation section of this manual.
7