A WARNING: To avoid serious injury, before performing any service and adjustments:
1.Release control bar and stop engine.
2.Make sure the blade and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place wire where it cannot come in
contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear wheels of your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator mowing position. If the deflector becomes damaged, it should be replaced.
TO REMOVE DRIVE BELT
1.Remove screws securing rear baffle.
2.Turn lawn mower on its side with air filter and carburetor down.
3.Remove rear baffle from mower.
4.Remove blade bolt, Iockwasher, hard- ened washer and blade.
5.Remove debris shield.
6.Remove gearcase belt keeper.
7.Remove drive belt.
| Gearcase |
| belt keeper |
Rear | Belt |
| retainer |
Gearcase | |
pulley |
|
\\i | '} |
Blade |
|
adapter \
'}
Debris shield
TO REPLACE DRIVE BELT
1.Place new drive belt on gearcase pul- ley.
NOTE: Always use factory approved belt to assure proper fit and long life.
2.Reinstall gearcase belt keeper. Be sure the new drive belt is inside the
tabs of the gearcase belt keeper.
3.Position the blade adapter on the en- gine crankshaft. Be sure key in adapter and crankshaft keyway are aligned; and that the new drive belt is inside the tabs of the belt retainer.
4.Place rear baffle in mower housing.
5.Reinstall debris shield.
6.Reinstall blade.
7.Return mower to upright position.
8.Reinstall rear baffle screws.
TO ADJUST HANDLE
Your handle has three (3) height positions
-adjust to a height that suits you.
1.Remove knob and carriage bolt on one side of the lower handle.
2.While holding handle assembly, remove knob and carriage bolt from
opposite side, align hole in handle with desired hole in handle bracket and
reassemble bolt and knob and tighten securely.
3.Align opposite side of handle with same positioning hole and secure with bolt and knob.
Handle bracket
Knob
Bolt
Hardened |
|
|
Blade |
| Blade |
|
| bolt |
| Lockwasher | 16 |
|
|