Parasound A 31 manual Front Panel Operation, On-Off Button

Page 12

Front Panel Operation

On-Off Button

Push once to turn on the A 31. When the A 31 is turned on the blue glow around the On-Off button will be brighter, the red P badge will glow brighter and then the 3 channel indicators will illuminate blue. Push again to turn off the A 31. The front panel On-Off button will be disabled when the Turn On Options switch is set to Audio or 12V.

Whenever the A 31 is turned on, the soft blue glow behind its On-Off button will change to red for a few seconds as its internal circuits stabilize. Then the red glow is replaced by a brighter blue glow to indicate normal operation. If the glow remains red after turn on or while the amp is playing, it indicates activation of the A 31’s protection circuits and no sound will be heard from the speaker.

The A 31 protects itself from external conditions such as excessive heat, load impedance that is too low, or a short-circuited speaker connection or wire. After you correct the fault, the A 31 will resume operation. If the A 31 remains “in protection” after it has cooled down and you’ve confirmed there are no external faults, it could indicate an internal problem.

Please contact Parasound’s Technical Service Department.

Channel Indicators

When all three blue channel indicators are lit, the A 31 is operating normally. If one or more of the indicators do not light even though the amp is turned on there is a fault in your system. In the case of a fault first check that there is no short circuit with your speaker wire or speakers.

Hi Temp Indicator

This indicator is near the right side of the panel recess. It will glow red if any channel overheats. The On-Off button will also glow red if the A 31 overheats. If such a condition occurs you must provide for better ventilation around the amplifier or check speakers for faulty operation that is causing the A 31 to over heat.

12

Image 12
Contents OWNER’S Guide Important Safety Instructions Table of Contents Important Warranty information Thank You for Choosing ParasoundParasound Staff Keeping Records for Future Reference Unpacking Your a 31 & Placement Guidelines AC Mains VoltageUnpacking Your a Rack Mounting Your Parasound a Audio Connections Audio Input ConnectionsSpeaker Wire Length and Gauge thickness Speaker ConnectionsSpeaker Terminals Correct Speaker Polarity is ImportantGain Control Settings When to Set the Gain Control Knobs Above or Below NormalTurn On Options Manual PositionAudio Position Automatic on/off 12V Position Automatic on/offAC Power Cord Volt Jacks12V In Jack 12V Loop Out JackFront Panel Operation On-Off ButtonTechnically Speaking Balanced and Unbalanced LinesGround Loops Eliminating Hum and Buzz Bare Speaker Wire Ends Power SupplyParasound a 31 Design Overview Circuit Designed by John CurlComplementary Configuration Relay-Bypassed Soft Start CircuitAudio Circuit Path Topology Input StageOutput Stage Class A-A/B OperationTotal Protection DC Servos Total Protection RelaysProblems and Remedies Unit will not turn onNo sound from speakers Background Hum or HissRepair or Service Are You Having Difficulty?Specifications Parasound Products, Inc McKinnon Ave, San Francisco, CA