CAUTION!Muffleris hot!Allowengineto
cool downbeforeproceedingwith bumper installation.
STEP 1 : (SEE FIGURE 2)
•Remove tractor hood. (Refer to tractor manual.) Remove the browning shield as shown below.
STEP 4: (SEE FIGURE 5)
Spread ends of bumper enough to fit slots onto bolts in rear mounting holes in tractor frame.
The bumper has three mounting holes. The rear hole provides the most clearance while the forward holes provide a neater appearance. Use a hole that provides enough clearance for hood to stay in raised position when opened. Insert a hex bolt (C) through tractor frame and into desired mounting hole on each side of bumper and secure with a hex nut (D).
IMPORTANT: Before fully tightening nuts, be sure tractor hood will stay in raised position when opened.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
FIGURE 2
STEP 2: (SEE FIGURE 3)
Insert a hex bolt (C) into the second mounting hole from the front of the tractor frame and fully tighten a hex nut
(D)onto the bolt. Repeat on other side of tractor.
HEX BOLT (C)
\
HEX NUT (D)
FIGURE 3
FIGURE 5
STEP 5: (SEE FIGURE 6)
•Replace the browning shield using the front screws you removed in Step 1.
STEP 3: (SEE FIGURE 4)
•Place plug (E) on a work bench or solid table and push end of bumper down onto plug. Repeat for second plug.
BUMPER
PUSH DOWN
WiTH EVEN
PRESSURE
WORK BENCH | SHORT STEP |
OR SOLID TABLE__ _=_.___.__ PLUG (E)
REPLACE
FRONTSCREWS
REPLACE
BROWNING SHIELD
FIGURE 6
FIGURE 4