Craftsman 358.792442 Tobeabout6inchesbelowthe Waist, Trimmer Head, Inches, Configuring Your Unit

Page 7

6.Adjustthestrap,allowingthehook

tobeabout6inchesbelowthe

waist.

7.Fastenthestraphooktotheclamp andliftthetooltotheoperating position.

8.Tryonshoulderstrapandadjust forfitandbalancebeforestarting theengineorbeginningacutting

operation. NOTE:Itmaybenecessarytorelo- catetheshoulderstrapclamponthe shaftforproperbalancingofunit.

ASSEMBLY INFORMATION -

TRIMMER HEAD

TRIMMER

HEAD

NOTE: Remove the blade and metal

HARNESS

ADJUSTMENT

FOR BALANCE

6 inches

 

below

4 = 12

waist

inches

 

above

._

ground

!

30 inches

CONFIGURING YOUR UNIT

You can configure your unit using a trim- mer head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch (1 cm) in diameter. To assemble your unit, go to the section for the desired configuration and follow the instructions.

shield before attaching the plastic shield and trimmer head. To remove blade, align hole in the dust cup with the hole in the side of the gearbox by rotating the blade. Insert a small screwdriver into aligned holes. This will keep the shaft from turning while loosening the

blade nut. Remove blade nut by turning clockwise. Remove the screwdriver.

Remove both washers and blade. To remove metal shield, loosen and re-

move the four mounting screws. See AT- TACHING THE METAL SHIELD and

INSTALLATIONOF THE METAL BLADE for

illustrations. Be sure to store all parts and instnJctions for future use.

INSTALLATION OF THE TRIMMER HEAD

NOTE: Before installing the trimmer head, make sure the dust cup and re- taining washer are positioned on the shaft of the gearbox. The retaining washer must be positioned with the raised section toward the gearbox.

1.Align hole in the dust cup with the hole in the side of the gearbox by rotating the dust cup.

2.Insert a small screwdriver into aligned holes. This will keep the

shaft from turning while tightening trimmer head.

Screwier _

3.While holding the screwdriver in position, thread trimmer head onto the shaft by turning counterclock- wise. Only tighten hand tightt

Image 7
Contents Brushcutter Attachment Sears, Roebuck and Co., D/817 WA, Hoffman Estates, IL Full ONE Year Warranty on Craftsman Brushcutter AttachmentAlways Wear Operator SafetyKeephandlesfreeofoilandfuel UNIT/MAINTENANCE SafetyFuel Safety Cutting SafetyHandlebar Assembly Installing Brushcutter AT TachmentOffeelingthefingers,hands,or Lower Shoulder Strap Shoulder Strap AssemblyPowerhead END Attachment Handlebar ScrewInches Configuring Your UnitTobeabout6inchesbelowthe Waist Trimmer HeadVvGearbox TrimmerHead Retaining WasherRemovethescrewdriver RemovewingnutfromshieldLeavethedustcupontheshaft Installthebladenutbythreading ontotheshaftcounterclockwiseGearbox SemblystepsareinthepartsbagBlade Shield Know Your Brushcutter Attachment358.792402 358.792421Cutting Methods Installing Optional ATTACH- MentInstalling Attachment Hanger Operating Position Always WearSweeping TrimmingScalping WingRecommended Cutting Position Generalrecommendations Care and Maintenance TaskLine Replacement Blade MaintenanceReplacing the Cutting Head Blade ReplacementPerform the following Seasonal Storage