Craftsman 917.25552 manual Mowing Tips

Page 13

,

=,,,=

,

, =

=,, ,,,,,,,,,,,, ,, ,,

m,m,L,

OPERATION

TO START ENGINE (See Fig. 7)

When starting engine for the first time or if engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine

Depress the clutch/brake pedal and set the parking brake.

Place gearshift lever in "NEUTRAL" position.

Move attachment clutch to "DISENGAGED" position

Move throttle control lever to "CHOKE" position for

cold engine start For warm engine start, move throttle control to "FAST" position

Turn ignition key clockwise to "START" position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If engine does not start after several attempts, move throttle control to "FAST" position, wait a few minutes and try again

When engine starts, move throttle control to desired position.

Allow engine to warm up for a few minutes before engaging drive or attachment clutch.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F), the carburetor fuel mixture

may ,need to be adjusted for best engine performance,

See TO ADJUST CARBURETOR in the Service and Adjustments section of this manual,

MOWING TIPS

Tire chains cannot be used when the mower hous- ing is attached to unit

Mower should be properly leveled for best mowing

performance. See "TO LEVEL MOWER HOUSING" m the Service and Adjustments section of this manual

Use the runner on the right hand side of mower as a guide. The blade cuts approximately an inch outside the runner (See Fig. 8).

The left hand side of mower should be used for trim_ ming.

Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distri- bution of clippings and more uniform cutting.

When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc, After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 9).

, , ,,

FIG. 9

If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clippings. Make first cut relatively high; the second to the desired height

Do not mow grass when it is wet, Wet grass will plug mower and leave undesirable clumps Allow grass to dry before mowing.

Always operate engine at full throttle when mowing to assure better mowing performance and proper discharge of material. Regulate ground speed by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

13

Image 13
Contents Model no Safety PrecautionsFull 90 DAY Warranty on Battery Product SpecificationsCustomer Responsibilities ModelNdex EN GI NE MAI NTE NAN CE Accessories AN Attach EntsPerformance Contents Assem Tools Required for AssemblyTo Remove Unit from Carton Unpack CartonAS E HOW to SET UP Your TractorCheck Deck Levelness Check for Proper Position of ALL BeltsInstall Battery See Figs AssemblyKnow Your Tractor SwitchOperation HOW to USE Your TractorBefore Starting the Engine OperatuonTo Transport ADD GasolineMowing Tips Lubrication Chart RK@ Maintenance SCHEDULE/oRegur Service Ates General RecommendationsTractor AintenanceBlade CareBattery See Fig MaintenanceCatch oil in a suitable container AIR Filter See FigMuffler CleaningSpark Plugs To Install Mower See Fig ERV CE a D AdjustmentsTo Level Mower Housing TractorLiftbracket To Adjust Mower Blade Drive Belt See Fig S1ERVUCEAN AdjustmentsBelt Installation Belt RemovalTo Replace Motion Drive Belt See Fig $ERVUCE and AdjustmentsImportant Replace only with Belt Listed in this Manual To Adjust Steering Wheel Alignment Service ANFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs SeeAdjustments Service ANHeadlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable ServiceTo Adjust Carburetor See Fig Engine BatteryOther Engine OILCorrection ProblemcauseProblem Troubleshooting POBNT$Cause Service Notes Schematic Repair Parts12.5 HP 38 Riding Lawn Tractor -- Model Number

917.25552 specifications

The Craftsman 917.25552 is a versatile lawn tractor designed to make lawn maintenance a breeze. This powerful machine offers exceptional performance and reliability, making it a popular choice among homeowners looking to keep their yards pristine.

One of the standout features of the Craftsman 917.25552 is its robust engine. The tractor is equipped with a dependable 24 HP Kohler engine, which provides ample power for cutting grass, tackling rough terrain, and handling various attachments and accessories. The engine is designed for efficient fuel consumption, ensuring longer operation times without frequent refueling.

The cutting deck of the 917.25552 is another highlight of this lawn tractor. It boasts a 54-inch steel cutting deck that offers a wide cutting path, allowing users to cover more ground in less time. The deck features a range of adjustable cutting heights, enabling operators to achieve their desired grass length easily. The three-blade design ensures a clean and precise cut, enhancing the overall appearance of the lawn.

In terms of user comfort, the Craftsman 917.25552 does not disappoint. It features an ergonomic seat designed to provide support during long mowing sessions. The adjustable seat height allows for a customizable fit, enhancing comfort and improving overall control. Furthermore, the tractor includes a convenient steering wheel and simple controls, making it easy for users of all experience levels to operate.

The tractor also incorporates advanced technologies, such as a hydrostatic transmission, which provides smooth and effortless speed control. This feature allows for easy navigation around obstacles, slopes, and various yard layouts. Additionally, the automatic transmission ensures a seamless driving experience without the need for constant gear shifting.

Safety is a crucial aspect of the Craftsman 917.25552. It comes equipped with safety features like a seat belt and a safety switch that automatically shuts off the engine if the driver leaves the seat. These features provide peace of mind while operating the machine.

In conclusion, the Craftsman 917.25552 is an impressive lawn tractor that combines power, efficiency, and user-friendly design. Its durable engine, large cutting deck, comfortable seating, advanced transmission, and essential safety features make it an excellent choice for homeowners seeking reliable lawn care solutions.