Craftsman 917 388111 To Assemble Grass Catcher, To Unfold Handle, To Install Attachments

Page 6

Read these instructions and this manual in its entirety before you attempt to assemble or operate your new lawn mower, IMPORTANT: This lawn mower is shipped WITHOUT OIL OR GASOLINE in the engine. Your new lawn mower has been as- sembled at the factory with the excep-

tion of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag.

TO REMOVE LAWN MOWER FROM CARTON

1.Remove loose parts included with mower.

2.Cut down two end corners of carton and lay end panel down flat.

3.Remove all packing materials except padding between upper and lower handle and padding holding operator

®presence control bar to upper handle.

4.Roll lawn mower out of carton and check carton thoroughly for additional loose parts.

Operator

MOWING

t

POSITION

control bar

_/////

 

/

/_///

 

//_//

 

Upper

UP

handle

 

 

Handle

 

knob

 

Lower handle

TO ASSEMBLE GRASS CATCHER

1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside

of the bag top.

2.Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold

them in warm water for a few

minutes.

If

bag gets wet, let it dry before

using.

÷

 

 

Frame

 

 

handle

\

HOW TO SET UP YOUR LAWN

MOWER

TO UNFOLD HANDLE

IMPORTANT: Unfold handle carefully so as not to pinch or damage control cables.

1.Raise handles until lower handle sec- tion locks into place in mowing position.

2.Remove protective padding, raise up- per handle section into place on lower handle and tighten both handle knobs.

3.Remove handle padding holding operator presence control bar to upper handle.

Your lawn mower handle can be adjusted for your mowing comfort. Refer to 'AD-

JUST HANDLE" in the Service and Adjust- ments section of this manual.

Vinyl

Frame

bindings

opening

TO INSTALL ATTACHMENTS

Your lawn mower was shipped ready to be used as a mulcher. To convert to bag- ging or discharging, see "TO CONVERT MOWER" in the Operation section of this manual.

388111-es-412691_r0indd

6

4_

2/23/2007

10:59:48AM

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Rotary Lawn Mower Sears, Roebuck and Co., Hoffman Estates, IL Warranty Maintenance 11-13 Safety Rules ServiceYour Safety is Involved AreasGeneral Operation II. Slope OperationDo not SAE General ServiceAwarning RJ19HXProduct replacement if your covered product cant be fixed Lawn Mower MaintenanceLawn Mower Performance To Install Attachments To Assemble Grass CatcherTo Unfold Handle Meets Cpsc Safety Requirements Know Your Lawn MowerWithout OIL Gasoline Converting Your Lawn Mower To Convert MowerADD Gasoline To Empty Grass CatcherBefore Starting Engine ADD OIL Mower is NOW Ready for Discharging OperationTo Start Engine To Stop EngineTo stop engine, release operator pres- ence control bar Mowing TipsGeneral Recommendations Before Each USELubrication Lawn Mower TiresMuffler AIR FilterRear Deflector Lawn Mower To Adjust Cutting HeightTo Adjust Handle LOW Position High PositionFold Forware HandleSqueeze To Fold ForCylinder OtherDoes not start Vibration Starter rope hard to pull ProblemcausePoor cut Never Grass catcherSU Seguridad Esta Comprometida III. Nifios HacerNo Hacer IV. Manejo Seguro DE GasolinaSobre 32F SAE 5W-30 Debajo 32F ServicioNOmero de Serie Capacidad De Aceite Onzas Bujia Abertura 030Acuerdo8 de Proteccion para la Reparacion Rendimiento DE LA SegadoraMantenimiento DE LA Segadora Para Remover LA Segadora DE Como Preparar SU SegadoraPara Desdoblar EL Mango Para Instalar LOS AooesoriosEn cada rueda Familiaricese CON SU SegadoraAjustador de la rueda ImportanteSegadoras CON Descarga Lateral Como Usar SU Segadora Velocidad DEL MotorPara Ajustar LA Altura DE Corte Para Convertir LA SegadoraPara Ensacamiento Trasero Pasos Simples DE RecordarPara Acolchamiento Para Descarga LateralPara Hacer Arrancar EL Motor Consejos Para Segar Y Acol CharDE Cada DE Cada Tabla DE LubricacknPuerta de la acolchadora Bisagra de la Puerta traser AlmaceReoogedor DE Oesped La torsi6n para apretar recomendada es de 35 40 pies librasPara Afilar LA Cuchilla Motor LubrioaoionFiltro DE Aire LimpiezaPara Cambiar EL Aceite DEL Motor Para Limpiar EL Filtro DE AirePara Ajustar EL Mango SegadoraDesviador Trasero Motor Velooidad DEL MotorMango MotorOtros Solucion DE ProblemasProblema Causa CorreccionCausa EmpujarCraftsman Rotary Lawn Mower - Model Number Axle Arm Assembly, Rear, RH Axle Arm Assembly, Rear, LHWheel & Tire Assembly, Front Discharge Deflector287 363@J3O4 Briggs & Stratton 4-CYCLE EngineOperators Manual 305Model Number 122T02=3845=EA Engine Power Rating informationBriggs & Stratton 4=CYCLE Engine 365 276Briggs & Stratton PTOBriggs & Stratton 4=CYCLE Engine KEY Part NO. NO.DESCRIPTIONInches Inch = 25.4 mm Service Notes Service Notes Service Notes A. and Canada Anytime, day or night U.S.A. onlyIiiiiiii!....!iiiiiii!ii!ii

917 388111 specifications

The Craftsman 917 388111 is a versatile and powerful riding mower designed for homeowners seeking efficiency and performance in lawn care. This model is well-known for its durability and ease of use, making it a popular choice among gardening enthusiasts.

One of the standout features of the Craftsman 917 388111 is its cutting system. It boasts a robust 42-inch cutting deck that provides a wide mowing path, allowing users to cover large areas in less time. The deck is adjustable, offering multiple height settings for a customized cut that can handle various grass types and terrain conditions.

Powering the Craftsman 917 388111 is a reliable 19 horsepower Briggs & Stratton engine. This engine delivers consistent power and performance, ensuring the mower can tackle even the toughest grass. The easily accessible choke and throttle controls make starting the mower simple, and the hydrostatic transmission allows for smooth operation, enabling the user to change speeds without the need for manual gear shifting. This feature greatly enhances maneuverability, especially in tight spaces or around obstacles.

The mower's design incorporates user-friendly elements, including an ergonomic seat and controls that are intuitively placed for easy access. The 917 388111 also features a 5-speed automatic transmission, which allows for effortless adjustments while driving. This convenience helps to reduce operator fatigue during extended mowing sessions.

Safety is a priority in the Craftsman 917 388111. The mower is equipped with a safety feature that automatically stops the blades when the operator leaves the seat, ensuring peace of mind while working.

In terms of maintenance, the Craftsman 917 388111 is designed for easy upkeep. The deck can be easily accessed for cleaning, and the inclusion of grease fittings on the front axle promotes longevity and reduces wear.

Overall, the Craftsman 917 388111 is an excellent choice for homeowners who want a dependable riding mower that combines power, precision, and user-friendly features. Whether tackling a small suburban lawn or a more expansive yard, this model stands out with its performance-driven design and thoughtful technologies.
Top Page Image Contents