Craftsman 132.24607 manual Problem, Cause

•Empty water tank completely, replace cap, and run system to evacuate all wa- ter in supply lines.

•Store misting nozzle assembly by folding over dash of tractor.

•Clean debris from venting on rear of power unit.

•Clean the power unit thoroughly with mild soap and water.

•Ensure the power switch on the power unit is in the "OFF" position.

PROBLEM			CAUSE
Pump	Not		1 .Switch	in OFF			Position
Running			2.Tractor	Key		in OFF Position
Unit not Misting			1 .Water	tank		is empty
			2.Adjustment			valve closed
			3.FilI cap not sealed
			4.Drain	plug	not		sealed
			5.Water	filter		needs replaced
			6.Basket	filter		missing
Water	streaming	from	1 .Water	in air		supply lines
Misting	Nozzle		(Tank	Overfull)
			2.Adjustment			valve setting
			3.Air filter needs				replaced
Inconsistent Misting			1 .Adjustment			valve changing
			)osition
Water	Dripping	from	1 .Drain	plug	not		seated
Drain Plug			2.Drain	plug	seal		is missing or
			damaged

CORRECTION

1.Toggle Switch to ON Position 2.Tractor Key to ON Position

1.Fill tank with DRINKING WATER 2.Open adjustment valve 3.Properly seat fill cap 4.Properly seat drain plug 5.Replace water filter

6.Install basket filter

1.Drain tank and run system until only air is emitted from nozzle 2.Close adjustment valve 3.Replace air filter

1.Adjust valve to desired mist den- sity and tighten locking nut against power unit housing

1.Properly seat drain plug 2.Replace drain plug seal

17