
TROUBLESHOOTING | CHART |
|
PROBLEM | CAUSE | CORRECTION |
Excessive vibration
Starter rope hard to pull
1.Wom, bent or loose blade.
2.Bent engine crankshaft.
1.Engine flywheel brake is on when control bar is released.
2.Bent engine crankshaft.
3.Blade adapter broken.
4.Blade dragging in grass.
1.Replace blade. 13ghten blade belt.
2.Contact an authorized service center.
1.Depress control bar to upper handle before
pulling starter rope,
2.Contact an authorized se_ce center.
3.Replace blade adapter.
4.Move lawn mower to cut grass or to hard surface.
Loss of drive | 1. | Drive |
| wheels | not turning | 1. | Adjust or replace drive control | ||||
|
| with | drive control | engaged. |
| cable. |
|
| |||
| 2. | Belt | not | driving |
| 2. | Put belt on pulleys or | ||||
|
|
|
|
|
|
|
|
| replace | belts | if broken. |
Grass catcher | 1. | Cutting | height too | low. | 1. | Raise | cutting | height. | |||
not filling (if so | 2. | Lift on blade | wom | oft. | 2. | Replace blade. | |||||
equipped) | 3. | Catcher | not venting air. | 3. | Clean | grass | catcher. | ||||
Hard to push | 1. | Grass | is too | high | or wheel | 1. | Raise | cutting | height. | ||
|
| height | is too | low. |
|
|
|
|
| ||
| 2. | Rear |
| of lawn | mower | 2. | Raise rear of lawn mower | ||||
|
| housing | or blade | dragging |
| housing one (1) setting | |||||
|
| in grass. |
|
|
|
| higher. |
| |||
| 3. | Grass | catcher too | full. | 3. | Empty grass catcher. |
4.Handle height position not 4. Adjust handle height to
right for you. | suit. |
18