Craftsman 917.386410 owner manual 3rass catcher Ot filling, Problem

PROBLEM

'7lowerstops

-CAUSE

o If high current light stays on momedtarily after mower stops, load is too much for m_wer.

If low power light stays on, mower slows down, lhen stops.

CORRECTION

o Remove fuse and turn mower all its side. Make sure blade is free to rotate. Also check mower

fol clogging.

o Batteries may be low, near the need of charging. Recharge batteries,

o Grass may be too heaw for remaining battery capacity Try the following:

• Walk slower.

,, Reduce cutting width

o Raise mower cutting heigh'

3rass catcher

_ot filling

Hard to push

•Cutting height tO low

Lift on blade worn off. Ca'tche_not ve_tir_g air.

,,Grass is too high or wheel height is leo low.

•Rear of lawn mower housing or blade dragging

in grass.

•Grass catcher'too full,

•Handle heiglit position not right for you,

- Raise cutting height

•Replace blade.

•Clean grass catcher.

,, Raise cutting height.

',Raise rear of lawn mower housing one (1) setting higher

o Empty grass catcher

. Adjust handle height to suit

Mower	Does	Not	Operator presence control
Stop when			bar is damaged.
Operator	Presence		. Start switch button sticks
Control	Bar	is	or damaged.
Released

,Replace operator presence control bar.

•Replace start switch button.

16