Craftsman 917.385125 Engine Speed, To Adjust Cutting Height, To Convert Mower, ADD Gasoline

The operation of any lawn sA_-r_sE_ mower can result in foreign

objects thrown into the eyes, which can result in severe eye damage. Always

wear safety glasses or eye shields while operating your lawn mower or performing any adjustments or repairs. We recom- mend a standard safety glasses or wide vision safety mask worn over spectacles°

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

The engine speed was set at the factory for optimum performance° It is not adjustable,

ENGINE ZONE CONTROL

,&CAUTION: Federal regulations require

an engine control to be installed on this lawn mower in order to minimize the

risk of blade contact injury°Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running,

,Your lawn mower is equipped with an operator presence control bar which

requires the operator to be positioned behind the lawn mower handle to start

and operate the lawn mower,

TO ADJUST CUTTING HEIGHT

Raise wheels for low cut and lower wheels

for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

•To change cutting height, squeeze ad- juster lever toward wheel° Move wheel up or down to suit your requirements, Be sure all wheels are in the same setting.

NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. Also, 9- position adjusters (if so equipped) allow lever

to be positioned between the plate tabs.

LEVER BACKWARD

TO LOWER MOWER

Plate

LEVER FORWARD TO RAISE MOWER

TO CONVERT MOWER

You r mower isshipped ready to be used as a mulcher. Toconverttobagging ordischarging:

•Lift discharge guard and remove mulcher plate,

•Mowercan now be used forside discharge or optional grass catcher can be attached.

•To return to mulching operation, simply reinstall mulcher plate as shown.

_CAUTION: Do not run your lawn mower

without discharge guard, approved grass catcher or mulcher plate in place.

Hinge rod

Discharge

Housing opening

Hooks

Mulcher plate Tab

BEFORE STARTING ENGINE ADD OIL

Your lawnmower is shipped without oil in the engine. For type and grade of oil to use, see "ENGINE" in the Maintenance section of this manual.

ACAUTION; DO NOT overfill engine with oil, or it will smoke heavily from the muffler

on startup.

t.Be sure lawnmower is level°

2.Remove oil dipstick from oil fill spout. 3, You receive a container of oil with the

unit. Slowly pour the entire container down the oil fill spout into the engine,

NOTE: Initial ell fill requires only 18 oz, due to residual oil in engine from the manufacturers 100% quality testing. When changing oil you may need 20 oz.

4.Insert and tighten dipstick,

IMPORTANT=

° Check oil level before each use. Add oil

if needed. Fill to full line on dipstick.

°Change the oil after every 25 hours of operation or each season. You may need to change the oi! more often under dusty, dirty conditions. See "TO CHANGE ENGINE OIL" in the Mainte- nance section of this manual.

ADD GASOLINE

•Fill fuel tank to bottom of tank filler neck. Do not overfill Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mixoll with gasoline, Pur- chase fuel in quantities that can be used

within 30 days to assure fuel freshness. _¢_CAUTION= Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.