Weed Eater EBV 200, 545117534 Clean air vents and air inlet of debris, Weed Eater

Page 10

SClean air vents and air inlet of debris.

S Store your unit and extension cord in a well ventilated area and covered, if pos- sible, to prevent dust and dirt accumula- tion. Do not cover with plastic. Plastic can- not breathe and may cause condensation and eventual rust or corrosion.

S Check entire unit for loose screws. Re- place any damaged, worn, or broken parts.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that re- quire unit to be operating.

SYMPTOM

CAUSE

 

REMEDY

Unit fails to

1.

Switch in the OFF position.

1.

Slide switch to ON position.

operate.

2.

Extension cord discon--

2.

Reconnect extension cord.

 

 

nected.

3.

Reset circuit breaker or

 

3.

Circuit breaker tripped, or

 

 

fuse blown.

 

fuse.

 

4.

Mechanical failure

4.

Contact your authorized

 

 

 

 

service dealer.

Unit

1. Mechanical failure

1.

Contact your authorized

vibrates

 

 

 

service dealer.

abnormally.

 

 

 

 

Impeller will

1. Debris in air intake area.

1. Clean unit. Remove any

not turn

2. Mechanical failure.

 

debris.

freely.

 

 

2. Contact your authorized

 

 

 

 

service dealer.

LIMITED WARRANTY

WEED EATER warrants to the original purchaser that each new WEED EATER brand electric or cordless product is free from defects in material and workman- ship and agrees to repair or replace un- der this warranty any defective WEED EATER brand electric or cordless prod- uct within two (2) years from the original date of purchase.

If your WEED EATER brand electric or cordless product should fail within the limited warranty period, return it, com- plete, prepaid, with proof of purchase, to the dealer from whom it was purchased for repair or replacement at the option of

WEED EATER.

This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance or the use of accessories and/or attachments not specifically rec- ommended by WEED EATER for this tool. Additionally, this warranty does not cover parts that will wear and require re- placement with reasonable use during the warranty period. This warranty does not cover predelivery setup or normal adjustments explained in the instruction manual.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

NO CLAIMS FOR CONSEQUENTIAL OR OTHER DAMAGES WILL BE ALLOWED, AND THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE EX- PRESSLY STIPULATED HEREIN.

SOME STATES DO NOT ALLOW LIMITA- TIONS ON HOW LONG AN IMPLIED WAR- RANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY NOT APPLY TO YOU.

The policy of WEED EATER is to con- tinuously improve its products. There- fore, WEED EATER reserves the right to change, modify, or discontinue models, designs, specifications, and accesso- ries of all products at any time without notice or obligation to any purchaser.

10

Image 10
Contents English Español FrançaisOperator Safety Safety RulesElectrical Safety Stop the motor immediately if you are ap- proached UNIT/MAINTENANCE SafetyDouble Insulation Construction Use only in daylight or in good artificial light Blower SafetyVacuum Safety MentsVacuum Assembly AssemblyBlower Assembly Standard screwdriver is required for as- semblyHOW to Convert Unit from Vacuum USE to Blower USE Collection BAG AssemblyAdjusting the Shoulder Strap on the Collection BAG Stop unit and unplug the extension cordExtension cord used to reach the power source must be Know Your Electric BlowerUsing Your Unit AS a Blower ON/OFF Switch Inlet RestrictorUsing Your Unit AS a Vacuum Inlet Cover Latch Tube Release ButtonService MaintenanceStorage Troubleshooting Table Symptom Cause Remedy Clean air vents and air inlet of debrisWeed Eater