Weed Eater SGT18H46A, 177599 manual Product Specifications, Customer Responsibilities

Page 4

PRODUCT SPECIFICATIONS

GASOLINE CAPACITY

3.5 GALLONS

 

AND TYPE:

UNLEADED REGULAR

 

 

OIL TYPE (API-SF-SJ):

SAE 30 (above 32°F)

 

SAE 5W-30 (below 32°F)

 

 

OIL CAPACITY:

W/FILTER: 5 PINTS

 

W/O FILTER: 4.5 PINTS

 

 

SPARK PLUG:

CHAMPION RN4C

(GAP: .030")

 

 

 

 

GROUND SPEED (MPH): FORWARD:

5.5

 

REVERSE:

2.4

 

 

 

TIRE PRESSURE:

FRONT:

14 PSI

 

REAR:

10 PSI

 

 

CHARGING SYSTEM:

3 AMPS BATTERY

 

5 AMPS HEADLIGHTS

 

 

 

BATTERY:

AMP/HR:

30

 

MIN. CCA:

240

 

CASE SIZE:

U1R

 

 

BLADE BOLT TORQUE:

27-35 FT. LBS.

 

 

 

CUSTOMER RESPONSIBILITIES

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your tractor.

Follow the instructions under “Customer Responsibili- ties” and “Storage” sections of this owner’s manual.

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily remedy, please contact your nearest authorized service centre/department. We have competent, well-trained tech- nicians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-cov- ered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your nearest authorized service centre/department (See RE- PAIR PARTS section of this manual).

4

Image 4
Contents Model NO. SGT18H46A Safety Rules Safe Operation Practices for Ride-On MowersTable of Contents Product Specifications Customer ResponsibilitiesUnassembled Parts Steering WheelNose Roller Gauge WheelsAssembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig To Attach Nose Roller See FigInstall Mower and Drive Belt See Figs Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Mower Cutting HeightTo Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Check Engine OIL Level See FigADD Gasoline To Start Engine See FigMowing Tips Purge Transmission¿ Lubrication Chart Customer ResponsibilitiesGeneral Recommendations Before Each USETractor Brake OperationTires Operator Presence SystemEngine Clean AIR Screen CleaningEngine Cooling Fins AIR FilterService and Adjustments To Install MowerTo Level Mower Housing To Remove Mower See FigFRONT-TO-BACK Adjustment See Figs To Replace Mower Drive BeltTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel Alignment Transmission REMOVAL/REPLACEMENTFront Wheel TOE-IN/CAMBER To Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points OFF Service Notes Schematic Tractor - Model Number SGT18H46AElectrical KEY Part Description Chassis 74760612 Bolt Fin Hex 3/8-16 Unc x 3/4 Drive Transaxle, Hydro Gear Model Steering Assembly KEY Part NO. NO. Description Engine 176174 Control, Throttle Mower Deck Repair Parts Mower Lift Washer 13/32 x 5/8 x 16 Ga Seat Assembly Decals Wheels & TiresLimited Warranty Suggested Guide for Sighting Slopes for Safe Operation