Weed Eater WE14542K owner manual Mowing Tips, To Start Engine See Fig

Page 13

OPERATION

TO START ENGINE (See Fig. 5)

When startingthe engine forthe first time or ifthe engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

Place gear shift lever in neutral (N) position.

•" "Move attachment clutch to "DISENGAGED" position.

Move throttle control to choke position.

NOTE: Before startirlg,

:" "

"

 

read the warm and cold starting

procedures below.

•Insert key into ignition and turn key clockwise to "START" position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast

position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the

choke position and retry.

WARM WEATHER STARTING (50 ° F and above)

When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine

and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-upperiod from several seconds to several minutes, depending on thetempera- ture.

•The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual.

MOWING TIPS

•Tire chains cannot be used when the mower housing is attached to tractor.

Mower should be properly leveled for best mowing performance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments sectior_ of 1his manual.

•The left hand side of mower should be used for trimming. D rive so that clippings are discharged onto the area that

has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of

clippings and more uniform cutting.

When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 7 ).

•If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

Always operate engine at full throttle when mowing to assure better mowing performance and proper dis- chargeof material. Regulateground speed by selecting a low enough gear to give the mower cutting perfor- mance as well as the quality of cut desired.

•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

f

lr

FIG. 7

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 14.5HP 42 Inch LawnTractor AssemblyGeneraloperation IV. ServiceI1. Slope Operation Do notContents Customer Responsibilities Product SpecificationsWheel Unassembled PartsKeys Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Babery See Fig Install Seat See FigCheck Tire Pressure Check for Proper Position of ALL BeltsCheck Deck Levelness Check Brake SystemOperation BatteryFast OIL PressureKnow Your Tractor To USE Throttle Control see FIG To Adjust Mower Cutting HeightTo Move Forward and Backward To Transport Before Starting the EngineMents To Operate on HillsTo Start Engine See Fig Mowing TipsGeneral Customer Responsibilities MAINTENANCESC.EDULERecommendations Before Each USETractor Customer ResponsibilitiesBrake Operation TiresEngine BatteryBelts Transaxle CoolingEngine Cooling Fins See Fig To Service PRE-CLEANERAIR Filter See Fig ScrewsblowerSpark Plugs CleaningMuffler IN-LINE Fuel Filter see FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower Belt Installation To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Both Front Links Must be Equal in LengthTo Adjust Steering Wheel Alignment To Adjust Brake See FigTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERInterlocks and Relays Replacing Battery SeeTo Replace Fuse To Remove CABLES, Reverse OrderTo Adjust Carburetor To Adjust THROnLE Control Cable See FigFuel System OtherEngine OIL CylindersTroubleshooting Points Travel speed Problemcause CorrectionTractor - Model Number WE14542K Schematic2122 ElectricalKEY Part Description ElectricalChassis and Enclosures 155138 Drive Tractor . Model Number WE14542K116 1202 204 T70 151 471KEY Part NO. no DrivePulley Idler V Groove Plastic Retainer Belt Style SpringPage 140044 Steering AssemblyEngine Optional Equipment29\ Repair Parts KEY Part NO. NO.DESCRIPTION Seat AssemblyKEY Part Wheels & Tires Decals1718 20 \ Mower LiftMower Lift Tractor -- Model Number WE14542K142 14 jr 19J Mower Deck130832 Service Notes Limited Warranty Products And Items Not Warranted No Dealer WarrantyProducts Warranted Only Ride UP and Down Hill Sight and Hold this Level with SKY Line or TreeNot Across Hill SightingWeedeater

WE14542K specifications

The Weed Eater WE14542K is a robust and versatile string trimmer designed for homeowners and landscapers looking for an efficient and reliable tool to tackle overgrown grass and weeds. This powerful machine is engineered with various features and technologies that enhance its performance and usability.

One of the standout features of the WE14542K is its lightweight design. Weighing just around 10 pounds, it's easy to maneuver, reducing fatigue during extended use. This makes it ideal for homeowners who need to manage their lawns without the strain of handling heavier equipment. The compact size also ensures that storage is hassle-free, fitting easily in sheds or garages.

Powering the WE14542K is a reliable 14-amp motor that delivers impressive cutting power. The electric motor eliminates the need for gas, which contributes to a cleaner and quieter operation, making it perfect for residential neighborhoods where noise restrictions may apply. The electric trimmer provides consistent power without the hassle of mixing fuel or dealing with emissions, thus being more environmentally friendly.

The Weed Eater WE14542K features a 42-inch cutting width, allowing users to tackle larger areas with fewer passes. This efficiency is complemented by its adjustable head, which can be angled for precision edging and trimming capabilities. The trimmer is equipped with a dual-line system that effectively reduces the time spent tidying up the edges of lawns, pathways, and garden beds.

Ergonomics play a significant role in the design of the WE14542K. It comes with an adjustable handle that allows users to find the most comfortable grip and angle for their height and preference. This feature not only ensures better control but also minimizes user fatigue during long sessions of work.

For added convenience, the Weed Eater WE14542K is designed with a push-button feed system. This allows for quick line advancement without the need for manual handling, saving time and effort in maintaining the cutting line. Additionally, the trimmer is constructed with durable materials that withstand everyday wear and tear, ensuring longevity.

In summary, the Weed Eater WE14542K combines power, convenience, and user-friendly features to deliver a superior trimming experience. Its lightweight design, potent motor, adjustable functionality, and durable construction make it an excellent choice for anyone seeking to maintain their outdoor spaces with ease.
Top Page Image Contents