CUSTOMER RESPONSIBILITIES
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.
ENGINE COOLING FINS (See Fig. 11)
Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating.
•Remove screws from blower housing and lift housing and dipstick tube assembly off engine.
•Cover oil fill opening to prevent entry of dirt.
•Use compressed air or stiff bristle brush to thoroughly clean engine cooling fins.
•To reassemble, reverse above procedure.
SCREWSBLOWER HOUSING
SCREWS
AIR SCREEN
OIL FILL
TUBE
ASSEMBLY
| SPARK |
ENGINE COOLING FINS | PLUG |
|
FIG. 11
AIR FILTER (See Fig. 12)
Your engine will not run properly using a dirty air filter. Clean the foam
Service air cleaner more often under dusty conditions.
•Remove knob(s) and cover.
TO SERVICE PRE-CLEANER
•Slide foam
•Wash it in liquid detergent and water.
•Squeeze it dry in a clean cloth.
•Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.
•If very dirty or damaged, replace
•Reinstall
•Reinstall cover and secure with knob(s).
TO SERVICE CARTRIDGE
•Remove cartridge nut.
•Carefully remove cartridge to prevent debris from enter- ing carburetor. Clean base carefully to prevent debris from entering carburetor.
•Clean cartridge by tapping gently on flat surface. If very dirty or damaged, replace cartridge.
•Reinstall cartridge, nut, precleaner, cover and secure with knob(s).
IMPORTANT: PETROLEUM SOLVENTS, SUCH AS KEROSENE, ARE NOT TO BE USED TO CLEAN THE CARTRIDGE. THEY MAY CAUSE DETERIORATION OF THE CARTRIDGE. DO NOT OIL CARTRIDGE. DO NOT USE PRESSURIZED AIR TO CLEAN OR DRY CARTRIDGE.
COVER
KNOB
| CARTRIDGE |
COVER | NUT |
PAPER
CARTRIDGE
FOAM
BASE
FIG. 12
17