Weed Eater 530163806 Troubleshooting Table Cause Remedy, Adjustment Crankshaft seals worn

Page 10

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit.

TROUBLE

 

CAUSE

REMEDY

Engine will not

1.

Engine flooded.

1. See “Starting a Flooded Engine”

start.

 

 

in Operation section.

 

2.

Fuel tank empty.

2. Fill tank with correct fuel mixture.

 

3.

Spark plug not firing.

3. Install new spark plug.

 

4.

Fuel not reaching

4. Check for dirty fuel filter; replace.

 

 

carburetor.

Check for kinked or split fuel line;

 

 

 

repair or replace.

 

5.

Compression low.

5. Contact an authorized service dealer.

Engine will not

1.

Fuel not reaching

1. Check for dirty fuel filter; replace.

idle properly.

 

carburetor.

Check for kinked or split fuel line;

 

 

repair or replace.

 

 

 

 

2.

Carburetor requires

2. Contact an authorized service dealer.

 

 

adjustment.

 

 

3.

Crankshaft seals worn.

3. Contact an authorized service dealer

 

4.

Compression low.

4. Contact an authorized service dealer.

Engine will not

1. Air filter dirty.

1. Clean or replace air filter.

accelerate,

2. Fuel not reaching

2. Check for dirty fuel filter; replace.

lacks power, or

 

carburetor.

Check for kinked or split fuel line;

dies under a

 

 

repair or replace.

3. Spark plug fouled.

3. Clean or replace spark plug

load.

 

 

and re-gap.

 

 

 

 

4. Carburetor requires

4. Contact an authorized service dealer.

 

 

adjustment.

5. Contact an authorized service dealer.

 

5. Carbon build up.

 

6. Compression low.

6. Contact an authorized service dealer.

Engine smokes

1. Choke partially on.

1. Adjust choke.

excessively.

2. Fuel mixture incorrect.

2. Empty fuel tank and refill with

 

3. Air filter dirty.

correct fuel mixture.

 

3. Clean or replace air filter.

 

4. Carburetor requires

4. Contact an authorized service dealer.

 

 

adjustment.

 

Engine runs hot.

1. Fuel mixture incorrect.

1. See “Fueling Engine” in Operation

 

 

 

section.

 

2. Spark plug incorrect.

2. Replace with correct spark plug.

 

3. Carburetor requires

3. Contact an authorized service dealer.

 

 

adjustment.

4. Contact an authorized service dealer.

 

4. Carbon build up.

-- 10 --

Image 10
Contents Manual de Instrucciones Manuel d’Instructions Handle Fuel with CAUTION, IT is Highly Flammable Know Your UnitPlan Ahead Operate Your Unit SafelyVacuum BAG Assembly Blower Tube AssemblyMaintain Your Unit Properly Outlet Vacuum Tube AssemblyHOW to Convert Unit from Vacuum USE to Blower USE VacuumThrottle Lever Shoulder Strap AdjustmentKnow Your Blower Primer ButtonBefore Starting Engine Fueling Engine Operating PositionOperating Tips To Stop the Engine Starting a Flooded Engine Starting a Cold Engine Starting a Warm Engine General RecommendationsCheck Muffler Mounting Screws Inspect and Clean Unit and DecalsClean AIR Filter Replace Spark PlugSeasonal Storage Carburetor AdjustmentsEngine OtherAdjustment Troubleshooting Table Cause RemedyAdjustment Crankshaft seals worn Carbon build upRecommended by Electrolux Home Tions The U.S. Environmental ProtectionGET Warranty Service Warranty ser Extended 300 hours