Weed Eater S165H42C owner manual Product Specifications, Customer Responsibilities

Page 4

PRODUCT SPECIFICATIONS

GASOLINE CAPACITY

2.0 GALLONS

 

AND TYPE:

UNLEADED REGULAR

 

 

OIL TYPE (API-SF-SJ):

SAE 30 (above 32°F)

 

SAE 5W-30 (below 32°F)

 

 

 

OIL CAPACITY:

3.4 PINTS

 

 

 

SPARK PLUG:

CHAMPION RN4C

(GAP: .030")

 

 

 

 

GROUND SPEED (MPH): FORWARD:

5.2

 

REVERSE:

2.7

 

 

 

TIRE PRESSURE:

FRONT:

14 PSI

 

REAR:

12 PSI

 

 

CHARGING SYSTEM:

3 AMPS BATTERY

 

5 AMPS HEADLIGHTS

 

 

 

BATTERY:

AMP/HR:

25

 

MIN. CCA:

190

 

CASE SIZE:

U1R

 

 

BLADE BOLT TORQUE:

27-35 FT. LBS.

 

 

 

CONGRATULATIONS on your purchase of a new tractor. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problem you cannot easily remedy, please contact your nearest authorized service center/department. We have competent, well-trained tech- nicians and the proper tools to service or repair this tractor.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tractor properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

•Read and observe the safety rules.

•Follow a regular schedule in maintaining, caring for and using your tractor.

•Follow the instructions under “Customer Responsibili- ties” and “Storage” sections of this owner’s manual.

WARNING: This tractor is equipped with an internal com- bustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-cov- ered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

A spark arrester for the muffler is available through your nearest authorized service center/department (See RE- PAIR PARTS section of this manual).

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Model NO. S165H42C IV. Service Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationTable of Contents Product Specifications Customer ResponsibilitiesSteering Wheel Seat Unassembled PartsSlope Sheet Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CAR- TONInstall Seat See Fig Lower seat into operating position and sit on seatCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips General Recommendations Customer ResponsibilitiesBefore Each USE Tractor Engine Cleaning AIR FilterMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Level Mower Housing To Remove Mower See FigTo Adjust Brake See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalTransaxle Motion Control Lever Neutral Adjustment See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigsTo Remove Wheel for Repairs See Fig To Attach Jumper CablesTo Adjust Carburetor To Replace Headlight BulbInterlocks and Relays To Replace FuseStorage OtherFuel System Engine OILTroubleshooting Points When operator leaves Schematic Tractor - Model Number S165H42CElectrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive Transaxle, Hydro Gear Steering Assembly KEY Part NO. NO. Description Engine Optional EquipmentMower Lift Seat Assembly Decals Wheels & TiresMower Deck 179292 Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation
Top Page Image Contents