Edge Guide
Shield 
2.Insert the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see following illustration).
3.Twist the shield as illustrated until the hole in the shield aligns with the hole in the housings. Make sure the shield is assembled to the unit as shown in the following illustration and in the KNOW YOUR UNIT section of this manual.
4.Install bolt into shield and motor hous- ing as shown. Tighten securely.
CAUTION: Sharp line limiter blade
Holes
Bolt
Twist shield in this direction to assemble
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
|
| Trigger Switch | Assist Handle |
|
|
|
| Twist and Edge Button | Motor Housing |
Cord |
| Clamp |
| Edge Guide |
|
|
| ||
Retainer |
|
|
| |
Recessed |
|
| ||
| Plug | Locking | Air |
|
|
| Sleeve |
| |
|
| Vents |
| |
|
| Assembly |
| |
|
|
| Trimmer Head | |
|
|
|
| |
|
|
| Debris Shield | with 0.065 inch |
|
|
|
| Trimmer Line |
Line Limiter Blade
RECESSED PLUG
The RECESSED PLUG is where you attach your extension cord to the unit.
TRIGGER SWITCH
The TRIGGER SWITCH is used to turn on the unit. Squeeze the trigger switchto operate the unit. Release to stop.
LINE LIMITER BLADE
The LINE LIMITER BLADE cuts the cutting line to the proper cutting length.
ASSIST HANDLE
The ASSIST HANDLE is used to help hold and guide the unit.
TRIMMER HEAD
The TRIMMER HEAD holds the cutting line and rotates during operation.
TWIST AND EDGE BUTTON
The TWIST AND EDGE BUTTON is used to twist the lower portion of the unit into an edg- ing position.
EDGE GUIDE
The EDGE GUIDE protects the unit fromcon- tacting the ground during edging.
5