CARTON CONTENTS
The following parts are shipped loose with your pressure washer:
•Main Unit
•High Pressure Hose
•Manual Bag (which includes the items listed below)
•Nozzle Cleaner Kit
•Accessories Adaptor
•Parts Box (which includes items listed below)
•Spray Gun
•Wand Extension
•Hi/Lo Adjustable Nozzle.
•Wire Form
•Motor Oil
Become familiar with each piece before assembling the pressure washer. Check all contents against the illustra- tion on Page 6, If any parts are missing or damaged, call the Pressure Washer Helptine at
TO REMOVE PRESSURE WASHER FROM CARTON
•Remove loose parts and parts box included with pres- sure washer. The high pressure hose is packed in the bottom of the carton on the guide handle end.
Remove the hose.
•Slice two corners at guide handle end of carton from top to bottom so the panel can be folded down flat, then remove all packing material.
•Raise guide handle, secure in place and roll the pres- sure washer out the open end of the carton.
Loosen knobs to raise handle
Tighten knobs when handle is
straight,
°Check carton for additional loose parts.
HOW TO SET UP YOUR PRESSURE WASHER
For the most part, your Craftsman High Pressure Washer has been assembled at the factory. You must, however, attach the wire form, assemble the spray gun, and attach the high pressure hose to the pump and spray gun,
•Insert the wire support with the longer arm positioned on the left. From this view the hook should resemble a
_J_
•Cut Ue wrap on chemical injec_on tube. Remove chemi-
cal injection filter, thread chemical injection tube through the wire form and reinsert filter into tube.