Sears 33731 manual Install the Left Side Bracket, Assemble the Grass Bag, Attach the rod hanger

ASSEMBLY AND OPERATION

Install the LEFT Side Bracket

Remove the Left Side Hardware

1.Remove the following from the left side of the upper handle, Figure 5. The hardware removed can be discarded.

•Two 1/4-20 screws

•Two flat washers

•Two 1/4-20 cap lock nuts

ASSEMBLE the Grass Bag

1.Place grass bag [A] over chute assembly [B], Figure 7.

2.Use the cable tie [I] to secure bag to chute assembly by inserting the cable tie into hole in bag and pulling through. Make sure cable is positioned so it ties bag around indented groove (over flange) of chute, Figure 7. Pull cable tight with pliers.

I

A

B

Figure 5

Install the Left Bracket

2.Align holes in rod bracket [E] with holes in panel while placing end of rod assembly [C] through the bracket. Secure with the following items from the hardware pack, Figure 6:

•Two 1/4-20 x 1.75” screws [F]

•Four flat washers [H]

•Two 1/4-20 cap lock nuts [G]

E

Figure 7

attach the rod hanger

1.Insert rod hanger [D] into the opening in the rod assembly [C], Figure 8.

2.Slide the tabs on the grass bag over the bag hanger rod, Figure 8.

D

C

C

F

H G

H

Tabs

Figure 8

Figure 6