Sears 917.25958 manual Customer Respons BIL Tues, Tractor, Blade Care, Battery

Page 17

CUSTOMER RESPONS BIL TUES

TRACTOR

Always observe safety rules when performing any mainte- nance.

BRAKE OPERATION

If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjuste& (See "TO ADJUST BRAKE" in the Service and Adjust- ments section of this manual),

TIRES

•Maintain proper air pressure in all tires (See "PROD- UCT SPECIFICATIONS on page 3 of this manual).

. Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

. Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local

parts dealer. Tire sealant also prevents tire dry rot and corrosion,

BLADE CARE

For best results mower blades must be kept sharp_ Re- place bent or damaged blades,

BLADE REMOVAL (See Fig. 12)

•Raise mower to highest position to allow access to blades.

•Remove hex bolt, lock washer and flat washer securing blade,

. Install new or resharpened blade with trailing edge up towards deck as shown.

Reassemble hex bolt, lock washer and flat washer in exact order as shown.

•Tighten bolt securely (30-35 Ft. Lbs, torque).

IMPORTANT: BLADE BOLT IS GRADE 8 HEAT TREATED

BLADE

MANDREL

 

 

 

TRAILING EDGE

FLAT WASHER

_

_

I

LOCK WASHER

_..

_l

 

HEX BOLT,

 

__

 

(GRADE 8) "__

*A GRADE 8 HEAT TREATED BOLT CAN BE IDENTIFIED BY SIX LINES ON THE BOLT HEAD.

FIG. 12

NOTE: We do not recommend sharpening blade- but if you do, be sure the blade is balance&

TO SHARPEN BLADE (See Fig. 13)

Care should be taken to keep the blade balance& An unbalanced blade will cause excessive vibration and even-

tual damage to mower and engine_

•The blade can be sharpened with a file or on a grinding wheel Do not attempt to sharpen while on the mower.

To check blade balance, you will need a 5/8" diameter seel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with bal- ancer)_

•Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground, If blade is balanced, it should remain in a horizontal position If either end of the blade moves downward, sharpen the heavy end until the blade is balance&

NOTE: Do not use a nail for balancing blade, The lobes of the center hole may appear to be centered, but are not,

CENTER HOLE

5/8" BOLT

BLADE

 

OR PIN

 

FIG. 13

BATTERY

Your tractor has a battery charging system which is suffi- cient for normal use However, periodic charging of the battery with an automotive charger will extend its life.

. Keep batteryand terminals clean.

•Keep battery bolts tighL

o Keep smallvent holes open.

•Recharge at 6-10 amperes for 1 hour.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power,

•Remove terminal guard.

Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor_

o Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until brighL

°Coat terminals with grease or petroleum jelly.

°Reinstall battery (See "CONNECT BATTERY" in the Assembly section of this manual)

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents AR8 I1. Slope Operation Safety is InvolvedII1. Children Limited 90 DAY Warranty on Battery Maintenance AgreementModel SEARS, Roebuck and CO,, 13/817WA, Hoffman ESTATES, ILIndex Performance ACCE$SORME$ and AttachmentsEngine Contents Tools Required for Assembly AssemblyTo Remove Tractor from Carton Unpack CartonPositive terminal must be connected HOW to SET UP Your TractorCheck Tire Pressure Check Brake SystemTo Convert to Bagging or Install Mulcher Plate See FigsDischarging FIGoMOl Checklis TChoke Mower Height Differential Parking Brake OperationOPERATmON Mower Blades HOW to USE Your TractorBefore Starting the Engine OperationTo Operate Iviower See Fig Check Engine OiL Level See FigMulching Mowing Tips Trash Clean After Each USEMowing Tips Customer Responsibilities Lubrication ChartGeneral Recommendatuons Before Each USECustomer Respons BIL Tues BatteryTractor Blade CareBelts EngineTo Service Cartridge Clean AIR INTAKE/COOLING AreasSparkplugs AIR Filter See FigEngine OIL Filter See Fig CleaningYear IN-LINE Fuel Filter See FigClutch To Install Mower See FigLowest position SuspensionBoth Front Links Must be Equal in Length $ERVJCE AdjustmentsRecheck measurements After adjusting Belt Installation Service and AdjustmentsTo Replace Mower Blade Drive Belt Belt RemovalFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTransaxle Shifter Linkage and AD Justment See FigsTo Remove Hood and Grill Assembly Loose or damaged wiring may cause your tractor to runTo Replace Fuse To Replace Headlight BulbFIG= To Adjust Throttle Control CableAcceleration Test Trou Leshootjng Points Correction Problem CauseEngune StorageOther Fuel SystemService Notes

917.25958 specifications

The Sears 917.25958 represents a distinct blend of functionality and durability in the realm of lawn maintenance equipment. This lawn tractor, engineered primarily for residential use, is well-known for its ability to handle a variety of yard tasks with relative ease.

One of the main features of the Sears 917.25958 is its robust 17.5 horsepower engine. This powerful engine ensures smooth and efficient operation, enabling users to tackle both large and small lawns without any difficulty. Additionally, the engine is paired with a reliable automatic transmission system that allows for seamless shifting during operation, removing the need for manual gear changes and making it user-friendly for those who may not be experienced with traditional riding mowers.

The cutting deck is another standout characteristic of the Sears 917.25958. It boasts a 42-inch cutting width, which provides an impressive balance between maneuverability and mowing ability. The cutting deck can be adjusted for height, allowing for various grass lengths to be managed effectively, and it features mulching capabilities that recycle grass clippings back into the lawn, promoting healthy growth and reducing yard waste.

Comfort is a major consideration with the Sears 917.25958. It is designed with a high-back seat that provides added support during extended use, along with ergonomic controls that minimize strain on the operator. The steering system is responsive and offers high maneuverability, making it easy to navigate around obstacles like trees and flower beds.

In terms of technology, the Sears 917.25958 incorporates a cutting-edge ignition system for reliable starting in various weather conditions. Safety features include a blade brake that engages when the operator leaves the seat, ensuring that the blades stop spinning to prevent accidents.

In summary, the Sears 917.25958 combines power, ease of use, and comfort, making it an excellent choice for homeowners looking for a dependable lawn tractor. Its thoughtful design, versatile mowing options, and safety features come together to create a highly efficient tool that stands the test of time in the realm of outdoor maintenance. Whether for routine mowing or more intensive yard work, this tractor is equipped to handle the job with confidence and reliability.
Top Page Image Contents