SERVICE AN ADJUSTMENTS
TO LEVEL MOWER HOUSING
Adjust the mower white tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPEOIFICATIONS"on page 3 of this manual). Iftires are over or underinflated, you will not properly adjust your mower.
,Raise mower to its highest position.
oAt the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance"A" on both sides of mower should be the same or within 1/4" of each other.
If adjustment is necessary, make adjustment on one side of mower only.
-To raise one side of mower, tighten lift link adjustment nut on that side.
To lower one side of mower, loosen lift link adjustment nut on that side.
NOTE: Each full turn of adjustment nut will change mower height about 1/8".
=Recheck measurements after adjusting.
BOTTOM EDGE | BOTTOM | EDGE |
OF MOWER TO | OF MOWER TO | |
GROUND | GROUND |
|
IMPORTANT: DECK MUST BE LEVEL
NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WiLL STAY LEVEL
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.
Check adjustment on right side of tractor. Measure dis- tance"D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
°Before making any necessary adjust ments, check that both front linksare equal in length. Both links should be approximately
If links are not equal in length, adjust one link to same length as other link.
-To lower front of mower loosen nut "E" on both front
links an equal number of turns.
=When distance "D" is 1/8" to 1/2" lower at front than
rear, tighten nuts "F" against trunnion on both front links.
-To raise front of mower, loosen nut"F" from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns.
-When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut"F" against trunnion on both front links.
o Recheck
GROUND LiNE | A |
FiG. 20
_,, | \ | SUSPENSION |
| ARM |
FIG. 22
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
LIFT LINK
ADJUSTMENT NUT
FIG, 21
/
/
NUT "E"
NUT "F"_
FRONT LINKS | TRUNNION |
21 | FIG. 23 |