ASSEMBLY
Figure 5 GAUGE SHOE ASSEMBLY
5a. Assemble one of the Gauge Shoe halves (7) to Frame Angle (4) using 1/2" x
5b. Attach Gauge Shoe halves (7) together using 3/8" x 1" Carriage Bolt (12), 3/8" Washer (20), 3/8" Lockwasher (17), and 3/8" Nut (14).
(10)
Bolt, 1/2" x
Qty. 2
| 10 |
|
4 | 7 |
|
| 17 14 | |
| 20 | |
| 19 |
|
15 | 12 |
|
(19) | (15) |
Lockwasher, 1/2" | Nut, 1/2" |
Qty. 2 | Qty. 2 |
(12) | (20) | (17) | (14) |
Carriage Bolt, 3/8" x 1" | Lockwasher, 3/8" | Flat Washer, 3/8" | Nut, 3/8" |
Qty. 2 | Qty. 2 | Qty. 2 | Qty. 2 |
Figure 6 MOUNTING ADJUSTMENT
6a. Attach Cultivator to your Tractor Hitch in lowered position.
6b. Adjust Hitch Bracket on Cultivator to obtain desired depth of Cultivator.
6c. Cultivator should be parallel to ground. Adjust Plow Bolts (13) to level Cultivator Shanks. Pull Bar (3) may be inverted to increase depth of cultivation.
6d. Adjust Gauge Shoes (7) to maintain depth. Tighten all bolts securely.
IMPORTANT | Cultivator must be stabilized to eliminate |
|
"side to side" movement when cultivating crops. This is an adjustment on the Sleeve Hitch, refer to Sleeve Hitch Manual for instructions.
6e. If additional weight is needed (see page 3) concrete block should be attached to the center of the Pull Bar (3) with the Rod Tie Down (8), 3/8" Plain Washer (20), 3/8" Lockwasher (17), and 3/8" Nut (14).
| 8 |
| 3 |
13 | 20 |
| |
| 17 |
| 14 |
7 | 1007076 Rev. A |