SERVICE A
ENGINE
TO ADJUST THROTTLE CONTROL CABLE (See Fig. 38 & 39)
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
With engine not running, move throttle control lever to fast ('¢ep)position.
oCheck that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.
TO ADJUST CARBURETOR (See Fig. 40)
The carburetor has been present at the factory and adjust- ment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel. temperature, altitude or load. If the carburetor does not need adjustment, proceed as follows:
in general, turning the adjusting needles in (clockwise) decreases the supply of fuel to the engine giving a leaner fuel/air mixture. Turning the adjusting needles out (coun- terclockwise) increases the supply of fuel to the engnne giving a richer fuel/air mixture.
IMPORTANT: DAMAGE TO THE NEEDLES AND THE SEATS IN CARBURETOR MAY RESULT IF SCREW IS TURNED IN TOO TIGHT.
PRELIMINARY SETTING -
*Be sure you have a clean air filter, and the throttle control cable is adjusted properly (see above).
oWith engine off turn idle fuel adjusting needle in (clock- w_se)closing it finger tight and then turn out (counter- clockwise)
Turn main fuel adjusting needle in (clockwise) closing finger tight and then turn out (counterclockwise) 1turn.
FINAL SETTING -
oStart engine and allow to warm for five minutes. Make final adjustments with engine running and shift/motion control lever in neutral (N) position.
•With throttle control lever in fast ( ,1_ ) position, turn main fuel adjusting needle in (clockwise) until engine begins to die then turn out (counterclockwise) until engine runs rough. Turn needle to a point midway between those two positions
•Idle s_p_eedsetting - With throttle control lever in slow
(,_!) position, engine should idle at 1400 RPM. If engine idles too slow or fast turn idle speed adjusting screw in or out until correct idle is attained.
Idle fuel needte setting - With throttle control lever in
slow (_) position, _urn idle fuel adjusting needle in (clockwise) until engine begins to die and then turn out (coun[erclockwise) until engine runs rough° Turn needle to a point midway between those two positions.
Recheck idle speed, Readjust if necessary.
ADJU ENTS
ACCELERATION TEST -
•Move throttle control lever from slow
position. If engine hesitates or dies, turn idle mixture
screw out (counterclockwise) I/8 turn. Repeat test and continue to adjust, if necessary, until engine acceler- ates smoothly.
High speed stop is factory adjusted. Do not
IMPORTANT: NEVER TAMPER WITH THE ENGINE
GOVERNOR WHICH IS FACTORY SET FOR PROPER
ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE
THE FACTORY HIGH SPEED SETTING CAN BE
DANGEROUS
HIGH SPEED NEEDS ADJUSTING. CONTACT YOUR
NEAREST AUTHORIZED SERVICE CENTER! DEPARTMENT. WHICH HAS PROPER EQUIPMENT AND
EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.
CASING | STOP SCREW |
| SPEED CONTROL |
CLAMP \ | / | j" | LEVER |
/li;?1
FIG. 38
STOP
SPEED
CONTROL
LEVER
FroG.39
IDLE SPEED
ADJUSTING
SCREW
FIG, 40
25