Sears 917.258473 Before Starting the Engine, To Operate Mower See Fig, To Operate On Hills

Page 14

i

illlll

iilll

....

:

TO OPERATE MOWER (See Fig. 9)

Your tractor is equipped with an operator presence sens- ing switch Any attempt by the operator to leave the seat with the engine running andthe attachment clutcit engaged will shut off the engine.

-Select desired height of cut

•Start mower blades by engaging attachment clutch control

•TO STOP MOWER BLADES - disengage attachment clutch control

without either the entire grass catcher, ! on mowers so equipped, or the dis-

!_CAUTION: Do not operate the mower charge guard in place.

ATTACHMENT CLUTCH LEVER

"DISENGAGED" POSITIONATTACHMENT

"ENGAGED" LIFT LEVER

POSITION HIGH POSITION

TO OPERATE

ON HILLS

 

,_

hills with slopes greater than 15 ° and

..................CAUTION:

Do not drive up or down {

O

do not drive across any slope

 

I

i Ill ttll

, i Jl,Jl,i, I

,, ,i

lIt tl t t,

Choose the slowest speed before starting up or down hills

Avoid stopping or changing speed on hills

"If slowing ts necessary, move throttle control lever to slower position

tf stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake

Move gearshift lever to 1st gear Be sure you have aIJowed room for tractor to rol_ slightly as you restart movement.

To restart movement, slowly release parkingbrake and clutch/brake pedal

Make all turns slowly

TO TRANSPORT

•Raise attachment lift to highest position with attach_ ment lift control

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position

•Do not push or tow tractor at more than five (5) MPH

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor Use an appropriate means of tying hood to tractor (rope, cord, etc)

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL (See Fig. 14)

•The engine in your tractor has been shipped, from the factory, already filled with summer weight oil,

DISCHARGE GUARD

•Check engine oil with tractor on level ground

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level If necessary, add oil until

FIG. 9

"FULL' mark on dipstick is reached. Do not overfill

• For'cold weather operation you should change oil for easier starting (See "OIL VISCOSITY CHART" in the Customer Responsibilities section of this manual)°

• To change engine oil, see the Customer Responsibili- ties section in this manual

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Assembly I1o Slope Operation Safe Operation Practices for Ride-On MowersLU. Children Limited TWO Year Warranty on Craftsman Riding Equipment Maintenance AgreementProduct Specifications Customer ResponsibilitiesTable of Contents Performance Accessobi and AttachmentsEngine Maintenance Parts bag contents not shown full size Hardware PackBefore Rolling Tractor Offskid Tools Required for AssemblyTo Remove Tractor from Carton Unpack CartonInstall Seat See Fig HOW to SET UP Your TractorConnect Battery See Figs GrundingTo Convert to Bagging or Discharging Install Mulcher PlateSee Figs OperationCheck Deck Levelness AssemblyCheck Tire Pressure Check for Proper Position of ALL BeltsOperation LockKnow Your Tractor HOW to USE Your Tractor To Operate On Hills Before Starting the EngineTo Operate Mower See Fig To TransportTo Start Engine See Fig Mowing TipsADD Gasoline Operation Mulching Mowing TipsGeneral Recommendations Lubrication ChartCheck BatteryLevel/Recharge Before Each USETractor BatteryBilities TiresAIR Filter See Fig EngineLubrication Remove knobs and coverSpark Plugs NsibilitiesMuffler To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Both Front Links Must be Equal in Length AdjustmentsTo Level Mower Housing Install mower in reverse order of removal instructions CE and AdjustmentsTo Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigTo Start Engine with a Weak Battery AdjustmTo Adjust Steering Wheel Alignment To Remove Wheel for RepairsTo Replace Headlight Bulb To Remove Hood and Grill Assembly See FigTo Replace Fuse To Remove CABLES, Reverse OrderTo Adjust Carburetor See Fig Service and AdjustmTo Adjust Throttle Control Cable See Fig Final SettingImportant Never Cover Tractor Whfleengine Fuel SystemEngine OIL Cause Troubleshooting PointsProblem CorrectionTroubleshooting POnNTS Problem CausePage Ignition SchematicTractor - Model Number Your Tractor is Equipped with a Special BrownRepair Parts KEY Part Description Tractor --MODEL NumberElectrical Chassis and Enclosures KEY Part NO. NO. Description 74180512Drive 121 11874550412 KEY Part NO. no19151216 KEY PartSteering Assembly Repair Parts UncKEY Part Descripon Seat AssemblyTractor -- Model Number 144334 DecalsKEY Engine Optional EquipmentTractor --MODEL Number 161718 3219 Tractor -- Model Number Lift Arm Suspension MowerMower 132 105UNC 21 STD54143137 STD55t037 40 STD541437 Adj94 Spring, TorsionDana TRANSAXLE- Model Number Sprocket, 18T Dana Transaxle Model NumberKEY Part NO. no Description Spacer, 1.131 X I45 X A94868 Briggs & Stratton Engine Model Number 28N707, Type NumberValv E Overhaul KIT Carburetor Requires Special Tools To INSTALL. see RepairTractor - Model Number 917,258473 455 1006 8O3 601 209801 783Idle Speed Tractor -..MODEL Number 917,258473272614 005Puller, Flywheel 281361Page ViCE Notes SEI Notes MAX Only Ride UP and Down Hill Not Across HillGuideth Model Number Engine Model NO, 28N707, Type no For Repair SERVICE, Call this Toll Free NumberOwners Manual Part Number Part Description

917.258473 specifications

The Sears 917.258473 is a versatile lawn tractor that has earned a reputation for its reliability and performance in the field of gardening and landscaping. Designed to cater to a range of lawn care needs, this model combines innovative technology with user-friendly features, making it an excellent choice for both novice and experienced gardeners.

At the heart of the Sears 917.258473 is a powerful engine, typically offering a robust horsepower that ensures efficient mowing, trimming, and yard maintenance. This engine is designed for durability and ease of starting, often featuring an automatic choke system. The tractor's high-performance capabilities allow it to tackle larger lawns and uneven terrains with ease.

One of the standout features of the Sears 917.258473 is its cutting deck. With multiple cutting heights available, users can customize the length of their grass according to seasonal needs or personal preferences. The reinforced deck is not only sturdy but also designed for efficient grass collection and minimal clumping, ensuring a clean and polished lawn after each mow.

Maneuverability is another significant aspect of this lawn tractor. It is equipped with an ergonomic steering system that allows for easy navigation around obstacles such as trees and flower beds. The tight turning radius enhances its capability to operate in smaller yards without sacrificing performance.

Another notable characteristic is the inclusion of a hydrostatic transmission. This feature provides seamless speed adjustments without the need for manual shifting, making it simple to control the tractor's speed in various mowing conditions. Additionally, the Sears 917.258473 is often designed with a comfortable seat and user-friendly controls, allowing for prolonged periods of usage without fatigue.

Safety features are thoughtfully integrated into the design, including a seat switch that ensures the engine shuts off when the user leaves the seat. This enhances overall safety during operation, especially on slopes or uneven ground.

Overall, the Sears 917.258473 represents a great investment for homeowners seeking an efficient and reliable lawn care solution. With its potent engine, adjustable cutting deck, ease of maneuverability, and advanced technologies, it stands as a competitive option in the realm of lawn tractors, helping users achieve their desired lawn aesthetics with minimal effort.
Top Page Image Contents