Sears 917.258524 owner manual RVmCE

Page 21

RVmCE AND

--

::

,,iH,=l=,,,,tiH===

lll,i

TO LEVEL MOWER HOUSING

Adjust the mower while tractoris parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" onpage 3 of this manual). If tires are over or underinflated, you will not properly adjust your mower°

SIDE-TO-SIDE ADJUSTMENT (See Figs. 21 and 22)

=Raise mower to its highest position.

°At the midpoint of both sides of mower, measure height

from bottom edge of mower to ground. Distance"A"on both sides of mower should be the same or within I/4 of each other.

°If adjustment is necessary, make adjustment on one side of mower only.

=To raise one side of mower, tighten lift link adjustment nut on that side.

oTo lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut willchange mower height about 1/8".

o Recheck measurements after adjusting.

BOTTOM EDGE

BOTTOM EDGE

OF MOWER TO

OF MOWER TO

GROUND

GROUND

GROUND LINE

A

FIG. 21

ADJUSTMENTS

,,it,.....llll

FRONT-TO*BACK ADJUSTMENT (See Figs° 23 and 24)

IMPORTANT; DECK MUST BE LEVEL SIDE-TO-SIDEo IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS

NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS

EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor, Measure dis- tance"D" directly in front and behind the mandrel at bottom edge of mower housing as shown.

°Before making any necessary adjustments, checkthat both front links are equal in length. Both linksshould be approximately 10-3/8".

•If links are not equal in length, adjust one link to same length as other link.

°To lower front of mower loosen nut "E" on both front links an equal number of turns.

=When distance "D" is 1/8" to 1/2" lower at front than

rear, tighten nuts "F" against trunnion on both front links.

•To raise front of mower, loosen nut"F" from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns.

°When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut"F" against trunnion on both front links,

°Recheck side-to-side adjustment.

MANDREL

FIG. 23

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

LIFT LINK

ADJUSTMENT NUT

FIG. 22

NUT "E"

NUT

FRONT LINKS

TRUNNION

21

FIG. 24

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Assembly Safe Operation Practices for Ride-On Mowers ChildrenIi. Slope Operation Product Specifications Maintenance AgreementLimited TWO Year Warranty on Craftsman Riding Equipment Limited 90 DAY Warranty on BatteryIndex Performance Engine MaintenancePack ContentsHOW to SET UP Your Tractor Tools Required for AssemblyTo Remove Tractor from Carton Before Rollung Tractor OFF SkidCheck Tire Pressure AssemblyCheck Deck Levelness Check for Proper Position of ALLInstall Mulcher Plate See Figs To Convert to Bagging or DischargingOperation Engine on Engine OFF OperationLights on Lights OFF Hydro Models onlyCutting height OperationHOW to USE Your Tractor To Transport Before Starting the EngineTo Operate on Hills ADD GasolineTo Start Engine See Fig MowingtipsMulching Mowing Tips Desired heighLMaintenance Schedule Lubrication ChartGeneral Recommendations Ju tB deBeitsTens oTractor CustomerBrake Operation TiresTo Clean Battery and Terminals EngineLubrication To Service PRE-CLEANER Clean AIR Screen See FigIbilities AIR Filter See FigCusto Esponsh CleaningMuffler Spark PlugsTo Install Mower See Fig To Remove Mower See FigBothsioes RVmCE To Adjust Brake See Fig Service and AdjustmTo Replace Mower Blade Drive Belt See FigTo Adjust Steering Wheel Alignment Service a D AdjustmentsTo Start Engine with a Weak Battery See Fig Front Wheel TOE-INICAMBERAdjustm ServiceTo Replace Headlight Bulb Interlocks and RelaysAcceleration Test Final SettingTractor OtherEngine fooded 4 Bad spark plug, 5o Dirty air filter Problem Cause CorrectionMowerblades will not rotate Trou Hooting PointsPlug Seat Switch not OccupiedPosmoN Circuit MakeElectrical TRACTOR-- Model NumberElectrical KEY Part NO. NO. Description Tractor - Model NumberChassis and Enclosures KEY Part Description Tractor - Model NumberDrive Tractor --MODEL Number 917,2585245otl 11674490544 Tractor -- Model Number 917,258524Bracket, Transaxle Bearing, NylonSteering Assembly Tractor - Model Number 917,258524 Tractor --MODEL Number 917,258524 Seat AssemblyTRACTOR- Model Number DecalsWheels & Tires Optional Equipment Engine29\ Tractor - Model NUiViBER 917,258524 Mower Lift KEY Part NO. no Tractor -- Model NumberMower Deck Tractor -- Model NumberPart Description Peerless Transaxle Model Number 930-057A Cover, Transaxle Part REF Part Description NO. no790025 TeethTo INSTALL. see Repair 1022Briggs & Stratton Engine Model Number 28N707, Type Number Carburetor Overhaul KIT Briggs & Stratton Engine Model Number 28N707, Type Number130 137 123Gasket SET 801 Briggs & Stratton Engine -MODELNUMBER 28N707, Type Number311 544KEY Part NO. no Description 729A 225170 Housing, Starter363 281361Service Suggested Guide for SiGHTiNG Slopes for Safe Operation For Consumer Assistance HOT LINE, Call this Toll Free Number For Repair SERVICE, Call this Toll Free Number

917.258524 specifications

The Sears 917.258524 is a notable addition to the landscape of outdoor power equipment, specifically in the realm of lawn maintenance. This model, known for its durability and efficiency, represents a standard of excellence in residential lawn care machinery.

One of the main features of the Sears 917.258524 is its powerful engine. Equipped with a reliable gasoline engine, this model offers robust performance that allows users to tackle a wide variety of lawn conditions, from smooth suburban lawns to rugged terrains. Its engine is designed to provide high torque, enabling the mower to cut through thick grass and even overgrown areas with ease.

The cutting deck of the 917.258524 is another standout feature. With a generous width, typically around 21 inches, it allows for efficient mowing over larger areas in a shorter amount of time. The adjustable cutting height is a practical attribute, offering multiple settings for different grass types and seasonal conditions. This versatility ensures that users can maintain their lawns at the desired height across various weather patterns.

In terms of technology, the Sears 917.258524 incorporates a self-propelling mechanism, making it easier for users to maneuver across slopes and uneven ground without excessive physical effort. This feature is particularly beneficial for those who may find traditional push mowers cumbersome.

The mower also boasts a user-friendly interface, often equipped with easy-to-reach controls for starting and stopping the engine, as well as for adjusting the speed and cutting height. This intuitive design enhances the overall user experience, making it accessible even for beginners.

Durability is a key characteristic of the Sears 917.258524. Constructed with high-quality materials, both the chassis and the cutting deck are designed to withstand the elements and resist corrosion. This ensures that the mower maintains its performance and appearance over time, providing long-lasting value to consumers.

Finally, the Sears 917.258524 takes maintenance into consideration. With features that simplify cleaning and oil changes, users can easily care for their mower, ensuring it remains in peak condition year after year. Overall, the Sears 917.258524 stands out as a reliable, efficient, and user-friendly option for homeowners seeking to keep their lawns well-manicured.
Top Page Image Contents