McCulloch MC2042YT, 96042011500 manual Install belt on engine pulley M, in belt keepers G

Page 17

SERVICE AND ADJUSTMENTS

ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring.

Repeat on opposite side of tractor.

A

B

Fig. 19

ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin (D) on rear mower bracket and secure with washer and retainer spring.

C

D

Fig. 20

Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J).

E

FJ

H

Fig. 21

Hook end of clutch cable spring (Q) into hole in idler arm (R).

Push clutch cable housing guide (P) into bracket, slide collar (L) onto guide and secure with retainer spring (K).

Install belt on engine pulley (M), in belt keepers (G).

M

Fig. 22

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

Raise attachment lift lever to highest position.

If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F).

R

Q

G MF

G

A E

P

B

C

K

 

L D

Fig. 23

17

Image 17
Contents Operators Manual Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Stop Mower Blades To Operate MowerReverse Operation System ROS To Operate on HillsMowing Tips Before Starting the EngineCheck Engine OIL Level ADD GasolineMaintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Belt Drive See FigTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsExcessive Suggested Guide for Sighting Slopes for Safe Operation Limited Warranty