5 - OPERATING INSTRUCTIONS
5 - OPERATING INSTRUCTIONS
5-3. WARM ENGINE START
1.Move ignition switch to the “RUN (I)” position.
2.Place choke in START “ ” position (Fig.
3.Grasp throttle handle firmly, squeeze throttle trigger to FULL position.
4.Pull starter rope briskly until engine starts, but no more than 6 times. Keep throttle at FULL position until engine runs smoothly.
5.If engine does not start, place choke in RUN “ ” posi- tion and pull starter rope 5 more times. If engine still does not start it is probably flooded. Wait 5 minutes and repeat procedure with choke in RUN “ ” position and throttle full open.
| A |
1. Occasionally, due to atmospheric conditions such as altitude it might be necessary to make slight adjustment to idle speed.
2.Insert phillips or flat screwdriver into access hole A (fig- ure
6 - TRIMMING INSTRUCTIONS
A
B
C
Release throttle trigger. Let engine return to idle. Move switch to “STOP” position. (Fig.
6-1. ADDITIONAL SAFETY PRECAUTIONS
Before operating your unit, review ALL SAFETY PRECAU- TIONS in this manual.
WARNING / CAUTION
• IF UNFAMILIAR WITH TRIMMING techniques, prac- |
tice the procedures with ENGINE in “OFF” position. |
• ALWAYS CLEAR WORK area of debris such as cans, |
bottles, rocks, etc. Striking objects can cause serious |
injury to operator or bystanders and also damage |
equipment. If an object is accidentally hit, immediately |
TURN ENGINE OFF and examine equipment. Never |
operate unit with damaged or defective equipment. |
• ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. |
Do not run engine slowly at start or during trimming |
operations. |
• DO NOT use equipment for purposes other than trim- |
ming or mowing weeds. |
• NEVER raise stringhead above knee height during |
operation. |
• DO NOT operate unit with other people or animals in |
the immediate vicinity. Allow a minimum of 50 feet (15 |
6-2. STRINGHEAD LINE RELEASE
WARNING / CAUTION
DO NOT use steel wire or
To release fresh line, run engine at full throttle and “bump” stringhead against lawn. Line will automatically release. The knife in debris shield will trim excess line (Figure
CAUTION
Be sure engine is off and string head has stopped before attempting to remove weeds wrapped around the shaft. Periodically weeds will wrap around the shaft. They will need to be removed or they will prevent the shaft from being properly cooled and could result in damage. Use a sharp object like a screw driver to remove them. (Fig.
BUMP
meters) between operator and other people and ani- |
mals when trimming or mowing. Allow a distance of |
100 feet (30 meters) between operator and other peo- |
ple and animals when SCALPING with stringhead cut- |
ting. |
• IF OPERATING UNIT ON A SLOPE, stand below the |
cutting attachment. DO NOT OPERATE on a slope or |
hilly incline if there is the slightest chance of slipping |
or losing your footing. |
10
11