Line Replacement, Installing Spool with Line

LINE REPLACEMENT

Pre--wound spools offer the most convenient method for replacing line and ensuring opti- mum performance.

S Replacement spools are color--coded to ensure use of the correct spool with your unit. Be sure to use the same color spool as the existing spool.

NOTE: Always clear dirt and debris from cut- ting head components when performing any type of maintenance.

SHold spool and unscrew cap by turning in

the direction shown on top of the cap.

SRemove line guide ring and spool.

INSTALLING SPOOL WITH LINE

1.Install replacement spool.

2.Thread line through line guide ring.

Line through guide ring

Slot

Replacement Spool

Cap

Line guide ring

Spool

3.	Rest guide ring on spool and place line in
	slot. Allow line to extend 4 -- 6 inches (10
	-- 15 cm) from center of spool.
4.	Ensure line remains in slot while screw-
	ing cap on to the shaft. Only tighten cap
	hand tight!

CARBURETOR ADJUSTMENT

Use a pre--wound spool or refill spool with line. If using a pre--wound spool, remove tape strip from line and spool.

REFILLING THE SPOOL WITH LINE

WARNING: Use only 0.080” (2 mm) diameter round line. Other sizes and shapes of line will not advance properly and will result in improper cutting head function or can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile that can cause serious in- jury.

1.Cut a length of 25 feet of 0.080” (2 mm) diameter round Weed Eater∀ brand line.

Feed line in direction shown on spool.

Spool

2.Insert one end of line into center cavity of empty spool. Ensure line will feed into spool in the direction shown on the spool (clockwise).

3.Continue feeding line into spool, leaving 4 -- 6 inches (10 -- 15 cm) unwound from center of spool.

WARNING: Keep others away when making idle speed adjustments. The trimmer head will be spinning during this procedure. Wear your protective equipment and observe all safety precautions.

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:

S Engine will not idle when the throttle is released.

Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).

S Turn idle speed screw clockwise to increase engine speed if engine stalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed.

Idle Speed

Screw

Air Filter

Cover

If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer or call 1--800--554--6723.