Line exit holes | Line in Notch | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Line in Notch
Hub
5.Wind the line evenly and tightly onto the spool. Wind in the direction of the arrows found on the spool.
6.Push the lines into the notches, leaving 3 to 5 inches (7
7.Insert the lines into the the exit holes in the hub as shown in the illustration.
8.Align the notches with the line exit holes.
9.Push spool into hub until it snaps into place.
10.Pull the lines extending outside of the hub to release the lines from the notches.
REPLACING THE CUTTING HEAD
1.Align hole in the dust cup with the hole in the side of the gearbox by rotating the dust cup.
2.Insert a small screwdriver into aligned holes. This will keep the shaft from turn- ing while removing and installing trimmer head.
4.Thread replacement trimmer head onto the shaft by turning counterclockwise. Tighten until secure.
5.Remove the screwdriver.
CARBURETOR ADJUSTMENT
WARNING: Keep others away when making idle speed adjustments. The trimmer head will be spinning during this procedure. Wear your protective equipment and observe all safety precautions.
The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:
S Engine will not idle when the throttle is released.
Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler.
Idle Speed Adjustment
Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).
STurn idle speed screw clockwise to increase engine speed if engine stalls or dies.
STurn idle speed screw counterclockwise to decrease engine speed.
Screwdriver
3.While holding the screwdriver in position, remove trimmer head by turning clock- wise.
Idle Speed
Screw
Air Filter
Cover
If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer or call
WARNING: Perform the following steps after each use:
SAllow engine to cool before storing or trans- porting.
SStore unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.
SStore unit with all guards in place. Position unit so that any sharp object cannot acci-
dentally cause injury.
SStore unit and fuel well out of the reach of children.
SEASONAL STORAGE
Prepare unit for storage at end of season or if it will not be used for 30 days or more.
If your unit is to be stored for a period of time: S Clean the entire unit before lengthy
storage.
SStore in a clean dry area.
S Lightly oil external metal surfaces.
FUEL SYSTEM
Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.
Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.
ENGINE
SRemove spark plug and pour 1 teaspoon of 40:1,
the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.
SReplace spark plug with new one of recom- mended type and heat range.
S Clean air filter.
8