
If the tractor does not come to a complete stop when the brake pedal is completely depressed, or if the tractor’s rear wheels can roll with the parking brake applied, the brake is in need of adjustment. The brake disc can be found on the right side of the transmission in the rear of the tractor. Adjust if necessary as follows:
•Looking at the transmission from the right side of the tractor, locate the compression spring and brake disc. See Figure 15.
Hex Nut
Set Gap at .011"
Brake Disc | Compression |
| Spring |
Transmission
NOTE: View shown from beneath tractor.
Figure 15
•Loosen, but do NOT remove, the hex nut found on the right side of the brake assembly. See Figure 15.
•Using a feeler gauge, set the gap between the brake disc and the brake puck at .011".
•
Seat Adjustment
WARNING: Before operating this machine, make sure the seat is engaged in the seat stop, stand behind the machine and pull back on seat until fully engaged into stop.
Quick-Adjust Seat (if so equipped)
To adjust the position of the seat, move the seat adjustment lever to the left and slide the seat forward or rearward. Make sure seat is locked into position before operating the tractor.
Knob Adjustment Seat (if so equipped)
To adjust the position of the seat on models so equipped, loosen the two knobs on the bottom of the seat. Slide the seat forward or backward as desired. Retighten the two knobs.
Steering Adjustment
If the tractor turns tighter in one direction than the other, or if the ball joints are being replaced due to damage or wear, the steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths are threaded into the ball joint on the left side and the ball joint on the right side:
•Loosen the jam nut found on the drag link at the rear of the ball joint. See Figure 16.
Hex | Pivot Bar |
| |
Axle |
|
| Drag Link |
| Jam Nut |
| Ball Joint |
Figure 16
•Remove the hex
•Thread the ball joint toward the jam nut to shorten the drag link. Thread the ball joint away from the jam nut to lengthen the drag link.
•Replace
NOTE: Threading the ball joints too far onto the drag links will cause the front tires to
Front tire
•Place the steering wheel in position for straight ahead travel.
•In front of the axle, measure the distance horizontally from the inside of the left rim to the inside of the right rim. Note the distance.
•Behind the axle, measure the distance horizontally from the inside of the left rim to the inside of the right rim. Note the distance.
•The measurement taken in front of the axle should be between 1/16" and 5/16" less than the measurement taken behind the axle. Adjust if necessary.
19