5. Follow steps below to assemble the grass catcher |
(if needed). Make certain bag is turned right side |
out before assembling (warning label will be on the |
outside). |
a. Place bag over frame so that its black plastic side |
is at the bottom. |
b. Slip plastic channel of grass bag over hooks on the |
frame, Figure |
center top of bag attach from outside of bag. |
A
3
Setup and
Adjustment
c. | Attach center top of bag from inside of bag. |
6. Follow steps below to attach grass catcher: | |
a. | Lift rear discharge door. |
b. Place grass catcher on the pivot rod. Let go | |
| of discharge door so that it rests on the grass |
| catcher, Figure |
To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up and out, off of the pivot rod. Release rear discharge door to allow it to close rear opening of mower.
WARNING: Never operate mower unless the hooks on the grass catcher are firmly seated
on the pivot rod and the rear discharge door rests firmly against top of the grass catcher.
Adjustments
An adjusting plate and thumb lever at each wheel provides cutting height adjustment.
1.Depress lever towards wheel.
2.Move it to any one of the positions for desired cutting height, Figure
3.Release lever towards mower deck.
C
B 
Figure 3-5: Assemble the grass catcher (if needed).
WARNING
Never operate mower
unless the hooks on the
grass catcher are firmly
seated on the pivot rod
and the rear discharge
door rests firmly against top of the grass catcher.
�
�
Figure 3-6: Attach the grass catcher.
�
�
�
Figure 3-7: Use adjustment levers at each wheel to change the cutting height.
7