Troy-Bilt CS4265 manual Know Your Chipper Shredder, Attaching The Tow Bar Model CS4210 Only

Attaching The Debris Collection Bag

•To attach the bag, place the opening of the bag completely over the chute deflector.

•Position the bag so that the wing knobs which secure the chute deflector to the impeller housing are completely covered.

•Pull on the drawstrap until the bag is tight around chute deflector opening.

Debris Collection Bag

Figure 2

Attaching The Tow Bar (Model CS4210 Only)

•To attach the tow bar, remove the spring pin and clevis pin from the end of the tongue.

See Figure 3.

Spring Pin

Tongue

Base

Clevis Pin

Figure 3

•Insert the tongue into the base. Reinsert the clevis pin through aligning holes in both the tongue and the base.

•Fasten with the spring pin to secure.

SECTION 3: KNOW YOUR CHIPPER SHREDDER

Read this operator’s manual and safety rules before operating your chipper shredder. Compare the illustrations in Figure 4 with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.

Engine Controls

See the Briggs & Stratton Owner/Operator manual packed with your unit. for the location and function of the controls on the engine.

Starter Handle

The starter handle is located on the engine. Pull the starter handle to start engine. See Figure 4.

Spring Latch

The spring latch is located on the top of the hopper. It is used to release or lock the chipper chute in a raised position for storage or for transporting. See Figure 4.

WARNING: Never operate the chipper shredder with the chipper chute in the raised position. Use the spring latch to lower the chipper chute into the operating position before starting the engine.

Lock Rod

The lock rod is located on the chipper chute support. It is used to release or lock the chipper chute in a lowered position for operation. See Figure 4.

Chipper Chute

Branches up to 3” in diameter may be fed into the chipper chute for chipping. See Figure 4.

Hopper

Leaves, twigs and branches up to 1/2-inch in diameter may be placed into the hopper for shredding. See Figure 4.

IMPORTANT: Never place branches with a diameter greater than 1/2-inch in the hopper. Doing so can result in serious damage to your unit’s shredder blade, flails or impeller.

Handle

Use the handle when manually transporting the chipper shredder.

6