Stop, Track Selection, Search | Musical Fidelity CD Pre24 specification

STOP

Playback can be stopped at any time by pressing the STOP button once.

TRACK SELECTION

To change track, the track skip buttons NEXT and PREVIOUS can be pressed to jump forwards or backwards one track in either direction. Note that a single press of the PREVIOUS button restarts play- back at the beginning of the current track. A double-press is needed to jump back to the previous track. Corresponding TRACK buttons on the remote control are also marked << and >>. If either button is held down, the CD Pre24 will quickly step through the available tracks in the required direction.

CD - BASIC OPERATION

track time remaining display (far right dig- its) will be seen to advance rapidly in the required direction. For both directions the unit will return to normal playback when the button is released.

DISPLAYING PLAYBACK TIME

There are three playback time display modes accessed progressively by pushing the TIME button on the remote control. The default mode (e.g. after switch on) shown below indicates the elapsed time for the currently playing track (2 minutes

34 seconds in this example):

TRACK SELECTION (Remote control)

A specific track can be selected directly by pressing the required track number button on the remote control. The chosen track then plays immediately.

To play a track number with two digits, press the 10+ button on the remote control followed by the first digit, then the second digit. For example, to obtain track 27, press 10+ , then 2, then 7.

SEARCH

The SEARCH buttons can be used to fast- forward or fast-rewind during playback in a similar way to a video or tape cassette player. This permits location of particular passages at high speed with the audio play- back of the CD still active.

Pressing the forward-search button (>>) fast winds forwards whilst the search back- wards button (<<) fast winds backwards. As the unit searches through a track, the

Pushing the TIME button once changes the display to show the remaining time for the current track (4 minutes 29 seconds in this example):

Pushing the TIME button again changes the display to show the remaining time for the whole disc (33 mins 54 secs) below:

(Note: Track and Index displays are not shown in this mode).

A third press of the TIME button will now bring the display back to the original (elapsed track time) mode.

Issue 4: May 2002

CD Pre24

Instructions for Use. Page 12 of 19