SECTION 5: UNPACKING
Removing Unit From Carton
•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
•Remove loose parts if included with unit (i.e., Operator’s manual, etc.). See Figure 2.
|
|
| ’s | |||||
|
| r | ||||||
| o |
|
|
|
|
|
| |
| t |
| l | |||||
a |
| |||||||
r |
| a | ||||||
e u |
|
|
|
|
|
| ||
p n |
|
|
|
|
|
|
| |
O a |
|
|
|
|
|
|
|
|
M |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FIGURE 2
•Cut along dotted lines and lay carton down flat. Remove packing material.
•Roll or slide unit out of carton. Check carton thoroughly for loose parts. See Figure 2.
NOTE: Make sure not to crimp the cable while removing the loose parts or the entire unit from the carton.
NOTE:Reference to right or left hand side of the mower and/or front or behind the mower is observed from the operating position.
SECTION 6: SETTING UP MOWER
Tools Required
•Pair of Pliers
•Funnel
Disconnecting Spark Plug
•Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it against the engine. See Figure 3.
•Attach rubber boot to a bolt on the engine to ground.
Spark Plug | Rubber Boot |
Wire |
|
Spark Plug
FIGURE 3
7