SECTION 8: SERVICE
WARNING: Always stop engine and disconnect spark plug wire before cleaning, lubricating or doing any kind of work on lawn mower.
Blade Control
Lubricate the pivot points on the blade control handle and the brake cable at least once a season with light oil. See Figure 10. The blade control must operate freely in both directions.
Wheels
Lubricate the wheel bearings (if so equipped) at least once a season with light oil (or engine oil). Also, if the wheels are removed for any reason, lubricate the surface of the axle bolt and the inner surface of the wheel with light oil.
Engine
Follow engine manual for lubrication instructions.
Lubrication Chart:
Lubricate
Lubricate Bearings
Figure 10
SECTION 9: MAINTAINING YOUR LAWN MOWER
WARNING: Be sure to disconnect and ground the spark plug wire before performing any repairs or maintenance.
NOTE: When tipping the unit, empty the fuel tank and keep engine spark plug side up.
Cutting Blade
WARNING: When removing the cutting blade for sharpening or replacement, protect hands by using heavy gloves or a rag to grasp the cutting blade.
To remove blade:
•Remove the bolt and blade bell support which hold the blade and adapter to the engine crankshaft. See Figure 11. Remove the blade and the adapter from the crankshaft.
WARNING: Periodically inspect the blade adapter for cracks, especially if you strike a foreign object. Replace when necessary.
Blade
Adapter
Blade Bell Support
Hex Bolt
Figure 11
•When sharpening the blade, follow the original angle of grind as a guide. It is extremely important that each cutting edge receives an equal amount of grinding to prevent an unbalanced blade. An unbalanced blade will cause excessive vibration when rotating at high speeds, may cause damage to the mower and could break, causing personal injury.
•The blade can be tested by balancing it on a round shaft screwdriver. Remove metal from the heavy side until it balances evenly. It is recommended that the blade always be removed from the adapter for the best test of balance.
11