Weslo WLHS86090 manual Using the Hydrotherapy Spa, Plugging in the Hydrotherapy SPA

Page 10

Using the Hydrotherapy Spa

The hydrotherapy spa is designed to seat four adults. The eight jets provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The hydrotherapy spa holds 200 gallons of water and offers a heating system (70¡F to 104¡F) and a filtration system.

The guidelines below explain how to properly use the hydrotherapy spa. Follow these guidelines to maintain the hydrotherapy spa for your long-term enjoyment.

PLUGGING IN THE HYDROTHERAPY SPA

Once the hydrotherapy spa is filled with water, the power cord can be plugged in and the spa can be turned on. Note: The first time the power cord is plugged in, the spa will turn on automatically.

When connecting the power cord, plug the power cord directly into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.

The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord. You should always test the GFCI before using the hydrotherapy spa.

Grounded circuit capable of carrying 15 or more amps

Test and Reset

Buttons

GFCI

First, turn on the hydrotherapy spa by pressing the On/Off Switch on the console. Once the unit is run- ning, press the GFCI ÒtestÓ button. The hydrotherapy spa should shut off. Press the ÒresetÓ button. The hydrotherapy spa should resume normal operation. If the hydrotherapy spa continues to run after the ÒtestÓ button is pressed, then the GFCI is damaged. Do not use the hydrotherapy spa until the GFCI has been repaired or replaced by a qualified electrician.

TESTING AND TREATING THE WATER

The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. Disregard the directions on the individual packages of ÒQUICK pHix It DOWNÓ and ÒQUICK pHix It UP.Ó However, the directions on the bottle of ÒNon-chlorine ShoxÓ and ÒBromine BaseÓ are correct. Always keep the chemi- cals away from children and pets.

The first time you use the spa, you should test and treat the water. You must also treat the water each time you refill the spa. Once you have verified that the spa is functioning properly, and have allowed the water to circulate for a while, you should remove the spa cover and add 1/3 of the ÒBromine BaseÓ bottle, and 1/3 of the ÒNon-chlorine ShoxÓ bottle to the water in the spa. Allow the water to circulate for five min- utes. You should now test the pH level of the water by using the included test strips. Refer to the test strip packaging for instructions on using the test strips. The pH reading should be between 7.2 and 7.8.

If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circu- late through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

If the level is too high, add half of one of the ÒQUICK pHix It DOWNÓ packets to the water. Let the water cir- culate through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

See WATER CHEMISTRY on page 14 for information concerning proper water maintenance.

STARTING THE HYDROTHERAPY SPA

Once you have tested the GFCI, you should verify the water flow from the pumping unit. Set the air control on the console to the lowest setting (see USING THE CONSOLE on page 12). The pumping unit will heat the water as it pumps. Cover the hydrotherapy spa with the spa cover. The spa cover must be tight (see SECURING THE SPA COVER on page 11). The water will heat at about 1.8¡F an hour with the cover on. If you are using the hydrotherapy spa indoors, and the room temperature is maintained at 70¡F, it will take approximately 18 to 22 hours for the water to reach the set temperature.

The temperature and water flow can be set or changed by the controls on the console (see USING THE CONSOLE on page 12).

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Customer HOT Line Model No. WLHS86090 Serial NoPatent Pending Table of Contents Posting the Warning SignImportant Safety Instructions Read and Follow ALL InstructionsPage Page Before You Begin Choosing a Location for the Hydrotherapy Spa If you set up the hydrotherapy spa insideIf you set up the hydrotherapy spa outside Do not use an extension cord with the hydrotherapy spaAssembly Exact position you want. Also make sure the spa Can be easily serviced, if needed. Once the spaShell. Before filling the spa, make sure it is Is filled with water, it must be drained to bePlugging in the Hydrotherapy SPA Using the Hydrotherapy SpaTesting and Treating the Water Starting the Hydrotherapy SPASecuring the SPA Cover Spa Shell DiagramSPA Operation Without the suction covers in placeConsole Diagram Using the ConsoleMaintenance Maintaining the Proper PH Balance Attaching and Removing the Access CoverWater Chemistry Draining the Hydrotherapy SPAYou can remove the pump/motor from the spa Winter USE and CareFrom the pump. Note For additional protection To store it in a climate-controlled roomMaintenance Notes Trouble-shooting Part ListÑModel No. WLHS86090 Key No. Qty DescriptionExploded DrawingÑModel No. WLHS86090 Limited One Year Massage Spa Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT

WLHS86090 specifications

The Weslo WLHS86090 is a versatile and compact treadmill designed for home fitness enthusiasts seeking an effective way to improve their cardiovascular health and overall fitness. With a combination of essential features and user-friendly technology, this treadmill caters to individuals of varying fitness levels.

One of the standout features of the Weslo WLHS86090 is its space-saving design. The treadmill includes a foldable frame, allowing users to easily store it when not in use. This is particularly advantageous for those with limited space, as it can be discreetly tucked away in a closet or corner of a room. Its lightweight construction also makes it easy to move around, providing flexibility for home workouts.

The treadmill is equipped with a powerful motor that offers a maximum speed of 10 miles per hour, allowing users to customize their workout intensity. With multiple incline settings, the WLHS86090 provides a challenging workout that can effectively target different muscle groups and enhance calorie burn. Whether you prefer a brisk walk or an intense run, this treadmill can accommodate your preferences.

One of the notable technologies integrated into the Weslo WLHS86090 is the built-in workout programs. These preset programs are designed to offer variety and motivation, helping users diversify their workouts while challenging their fitness levels. The user-friendly LCD display provides real-time feedback on key metrics such as speed, distance, time, and calories burned, enabling users to track their progress effectively.

Additionally, the Weslo WLHS86090 is designed with comfort in mind. Its cushioned deck helps reduce the impact on joints, making workouts safer and more comfortable. The treadmill also includes features such as sturdy handrails for added stability, ensuring users can maintain their balance during their workouts.

For those who enjoy listening to music while exercising, the treadmill features built-in speakers that can connect to devices via Bluetooth. This adds an entertainment element to workouts, making the experience more enjoyable.

In conclusion, the Weslo WLHS86090 treadmill is a practical choice for anyone looking to enhance their fitness routine at home. Its combination of space-saving design, adjustable speed and incline features, integrated workout programs, and user-friendly technology makes it an excellent investment for health-conscious individuals. Whether you are a beginner or a seasoned athlete, the Weslo WLHS86090 offers everything you need for an effective and enjoyable workout experience.
Top Page Image Contents