Wayne-Dalton HA-04WD operating instructions Specifications, Programming/Specification Compliance

4InstallationProgramming(Continued)

Refer to the instructions for the HA-07WD Deluxe Remote Control, HA-09WD Remote Control, or WDHA-12R Gateway Module for programming this device.

5 Specifications

For Indoor and Outdoor use in Dry, Damp and Wet Locations

Ratings:

15 Amperes Resistive

8.3Amperes Tungsten 120VAC, 60 Hz

Operating Temperature Range: -35˚ C to 60˚ C

Made In China

Programming/Specification

7

Compliance

FCC and IC Statement

FCC Regulatory Information: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

a)reorient or relocate the receiving antenna,

b)increase the separation between the equipment and receiver,

c)connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

IC Regulatory Information: This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

Cet appareillage numérique de la classe B répond a toutes les exigences de l’interférence canadienne causant des règlements d’équipement. L’opération est sujette aux deux conditions suivantes: (1) ce dispositif peut ne pas causer l’interférence nocive, et (2) ce dispositif doit accepter n’importe quelle interférence reçue, y compris l’interférence qui peut causer l’opération peu désirée.

WARNING: Changes or modifications to this receiver not expressly approved by Wayne-Dalton Corp. could void the user’s authority to operate this equipment.

© Copyright 2006 Wayne-Dalton Corp. Part No. 0000345 New 3/22/06

8You can reach us Toll Free 1-888-827-3667 for Consumer Assistance

or online at www.wayne-dalton.com/access