Installation & Setup Instructions
Mounting the Unit
TM
LTO
Your ADP Series Power Amplifier has two fixing 'ears' at each side, allowing it to be firmly screwed to a suitable surface. It may be mounted vertically or horizontally, but avoid mounting the unit upside down (suspended from a shelf, for example) since this may affect efficient heat dissipation. Do not mount the unit under carpeting or within a small sealed enclosure, as this will prevent proper ventilation. Take care not to mount the unit where it may become wet or subject to damage from items placed in the trunk area.
1Signal Inputs
The Left and Right Channel input terminals are standard unbalanced phono type sockets. Connect the
2Speaker Outputs
Connect suitable cables (not supplied) from the Output terminals of your ADP amplifier to your speaker inputs, taking care to ensure correct + / - polarity. Use the correct size Allen Key to tighten the screws of the speaker terminals.
IMPORTANT
The amplifier must not be run with any of its output channels open (i.e. not connected to a speaker). Running the amplifier in this way for even a short time can cause permanent damage.
3Power, Ground and Remote Switch-On Terminals
Caution: Before making any connections, you should disconnect power from the battery to avoid accidental
a. the cassette or CD player (which may require a code number to reactivate it. Do you know the code?)
b. the security system (which may trigger and sound an alarm from its
c. Memory modules (which may suffer memory loss if disconnected for too long).
If you have any doubts, you should seek professional assistance.
4