NETGEAR ANT24O5 manual Introduction, Package Contents

Page 2

Introduction

This section introduces the package contents of the NETGEAR 5 dBi Omni-directional Antenna ANT24O5 and related components.

NOTE: To obtain optimal results in extending wireless range with antenna installations, it is recommended that a qualified professional installer service is consulted for site survey and proper installation.

To comply with FCC rules the ANT24O5 antenna should only be used with devices that have been FCC approved for use with the ANT24O5. Please check the NETGEAR web site at http://www.NETGEAR.com/go/antennas_fcc for an updated list of FCC approved devices.

For EU, use of any antenna requires careful planning and extra consideration to comply with EU emissions and health standards and regulations. Antenna installation must comply with the maximum level authorized by each country, see page 9.

Package Contents

Installation Guide, Warranty card and

5 dBi Antenna

Support information card

ANT24O5

 

The package should contain:

•NETGEAR 5 dBi Omni-directional Antenna ANT24O5 including a 10 cm RG316 cable with a reverse SMA connector for IEEE 802.11b or 802.11g wireless devices

•Ceiling/Wall mount bracket hardware

•Warranty card

•Support information card

1

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Installation Guide Package Contents IntroductionPlacement and Other Important Considerations ANT24O5Installing the Antenna Wireless device with a single antennaDescription ANT24O5, 5 dBi Omni-directional SpecificationsReverse female jack SMA connector Description 10cm RG318Statement of Conditions Vertical Plane Radiation Pattern X-Z, ElevationRadiation Pattern Y-Z, Elevation Technical Support Support Information
Top Page Image Contents