Swisher ZT13536, ZT17542B, ZT20050, ZT20050, ZT13536, ZT17542B Controls, Starting Mower

Page 9

OPERATING YOUR NEW ZTR MOWER (cont.)

CONTROLS

_ OPERATOR PRESENCE SYSTEM: This mower is equipped with an operator’s presence system. Any attempt to leave the seated position while the engine running, without first disengaging the PTO switch and placing the steering levers in the neutral position will cause the engine to shut off.

_ WARNING: Do not operate the machine unless the Operator’s Presence System if functioning as described.

_ PARKING BRAKE: Always set the parking brake before starting. The parking brake is located on the drivers left hand side. Engage the parking brake by pushing the lever rearward and down until lever locks into position. Be sure to release parking brake before operating the machine.

_ IGNITION: The ignition switch is located on the drivers right hand side toward the rear of the seat. The ignition switch has three positions: OFF, ON,

START.

_ THROTTLE: The throttle\choke control is located on the drivers right hand side towards the front of the seat. For maximum performance and battery charging operate at full throttle. When starting a cold engine, place lever forward in the full choke position. After start up, move throttle rearward to full throttle position. Move lever all the way to the rear for lowest setting before shutting off engine.

_ PTO SWITCH: The PTO, or Power Take Off switch is used to engage the blades of the mower. When the PTO switch is pulled out the blades will be engaged. When the PTO switch is pushed in the blades will be disengaged. The PTO switch must be pushed in to complete the Operator’s Presence System to start engine.

_ NEUTRAL LOCK: The steering levers must be in the outward and locked position for the mower to start the engine. ( See page 13)

STARTING MOWER

•TO START: Position steering handles outward to neutral locked position. Engage parking brake. Extend throttle to full choke position*. Start ignition and slide throttle lever back to full throttle position. Allow engine to warm up for 1 minute. Release parking brake

•* Model ZT20050 has a remote choke assembly located on the right fender, behind the rider.

•FORWARD MOVEMENT: To move the mower forward gently push both steering levers forward equal distance from the neutral position. The further you move the levers forward the faster you will travel. CAUTION steering levers have quick response timing.

•BACKWARD MOVEMENT: To move the mower backwards, gently pull back on the steering levers the same distance from neutral. The further you pull back the faster you will travel. NOTE it is normal for the reverse speed to be less than the forward for easier turning.

•TURNS: For left turn, move the right lever farther forward then the left. For right turn, move the left lever farther forward than the right. To obtain a tight turning radius, GENTLY reverse one lever and push the other lever forward. CAUTION: Aggressive turns can damage lawns. Do not make turns with the inside wheel stopped. It it better to keep both wheels turning slightly.

•DECK HEIGHT ADJUSTMENT: To raise the mower deck up and down, simply rotate the lever located in front of the seat above the floor plate. Clockwise raises the deck. Counterclockwise lowers the deck. The deck is adjustable from 1 _” to 3 _”.

•For best performance, grass over 6 _” in height should be mowed once in the highest position and once again at desired cut height.

•ENGAGING BLADES: Operator must be seated for operation of blades. With engine to full throttle position, pull UP on PTO switch located between the throttle and the key switch. To disengage blades, push DOWN on PTO switch.

•STOPPING ENGINE: Place both levers in the outward neutral locked position. Push PTO switch in to disengage. Place throttle lever to lowest setting and let idle for 30 seconds. Turn off ignition key and engage parking brake.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Series Limited Warranty Table of Contents Safety Precautions & Decals Safety Precautions & Decals Safety Precautions & Decals Safety Precautions & Decals Slope Operation Operating Your NEW ZTR MowerStarting Mower ControlsMowing Maintenance Schedule Inspect Before Each USEInspect Every 8 Hours Inspect Check Every 100 Hours Inspect Every 25 HoursInspect Each Season Inspect Before StorageTracking Service / AdjustmentsRemoving the Mower Deck Installing the Mower DeckLeveling the Mower Deck Belts Clutch drive belt replacementItem # Description Overall Assembly3715 Blade Driver Engine SET-UP Transmission IdlerSeat Base Assembly Steering LeftControl Card Frame Deck LiftLower Belt Idler Mowing Deck Blade Belt Idler 96To Start TroubleshootingSwisher Mower & Machine CO. INC Zero Turn Hydrostatic Drive

ZT17542B, ZT13536, ZT20050, ZT20050, ZT13536, ZT17542B, ZT13536, ZT17542B, ZT20050 specifications

The Swisher ZT13536, ZT17542B, and ZT20050 represent a range of high-performance zero-turn mowers designed for residential and commercial lawn care. Each model offers unique features, technologies, and characteristics that cater to different mowing needs and preferences.

The Swisher ZT13536 is equipped with a robust 13.5 HP engine, delivering reliable and consistent power for various mowing tasks. Its 36-inch cutting deck ensures maneuverability in tight spaces, making it ideal for smaller yards. The zero-turn radius technology allows for sharp turns and efficient mowing around landscaping and obstacles, ensuring a precise cut every time.

In contrast, the Swisher ZT17542B caters to those needing greater cutting capacity and power. With a 17.5 HP engine and a wider 42-inch cutting deck, this model can handle larger lawns effectively. It also features an adjustable cutting height, allowing users to customize the grass length according to their preferences. The heavy-duty frame construction enhances durability, ensuring the mower withstands regular use over time.

The ZT20050 takes performance up a notch, showcasing a powerful 20 HP engine and a formidable 50-inch cutting deck. This model is designed for larger properties and commercial applications, where speed and efficiency are paramount. The ZT20050 features advanced technology such as electric start, making it easy to start with just the turn of a key. Its reinforced chassis and larger tires provide enhanced stability and traction, even on uneven terrain.

All three models feature a comfortable high-back seat and user-friendly controls, allowing for extended mowing sessions without fatigue. The intuitive dashboard display provides essential information, ensuring users are aware of their mower's operational status at a glance.

Safety is a priority in Swisher's designs, with features such as automatic blade shut-off when the operator leaves the seat, ensuring peace of mind during operation. The easy-to-access maintenance points make servicing these mowers straightforward, promoting longevity and performance.

In summary, the Swisher ZT13536, ZT17542B, and ZT20050 offer a range of options to suit different mowing needs, from residential lawns to expansive properties. With their powerful engines, user-friendly features, and robust designs, these zero-turn mowers are poised to deliver top-notch performance and satisfaction for any outdoor landscaping task.
Top Page Image Contents