IMPORTANT! - READ THIS MANUAL BEFORE OPERATING MOWER
Be sure to check your new Swisher Riding Mower for shipping damage before beginning assembly.
These parts are packaged with your new mower.
-
-
-
-Wheels
-CotterPins
The following tools are needed for assembling your new Swisher Riding Mower:
Safety Glasses 1/2” box wrench
2 - 7/16” box wrenches 7/16” socket and ratchet 5/32” hex key wrench
ASSEMBLY
To assemble your new mower, complete ALL of the following steps.
1. | INSTALL STEERING WHEEL | 1. | INSTALLING THE WHEELS |
• Align the key in the steering wheel hub |
| •Insert the axle through the hub of the wheel | |
| with the slot in the end of the steering shaft |
| with the valve stem facing away from the |
| and press down. |
| mower. (Be sure to place the supplied |
|
|
| spacers between the surface of the axle |
• Use a hex key wrench to install and tighten |
| weldment and the hub to prevent the tire | |
| the set screws on the side of the steering |
| from rubbing the weldment.) |
| hub. |
| •With the wheel in position, insert a cotter |
• |
|
| |
Insert the |
| pin in the hole on the end of the axle. Use | |
| washer into the steering hub. |
| pliers to spread the ends of the cotter pin |
|
|
| to retain the wheel in position. Repeat this |
• | Tighten the bolt until snug. Do not over- |
| process for the other side. |
| tighten |
| Important - Do not forget to spread the |
|
|
| ends of the cotter pins to keep wheel as- |
• Install the cap plug to cover the bolt and |
| sembly in place. | |
| washer. |
|
|
6