Light Kit Assembly Instructions

1.Separate the components and identify. Note, the left hand light has the clear window on the bottom. This is for the license plate illumination if needed

2.Un-tie and extend the wiring harness along the splitter. The Green & Brown wire go to the right hand side as the unit is towed. The Yellow & Brown wire go to the left hand side.

3.Note: a ground wire (White) is provided to assure proper grounding of the system.

4.Attach the mounting bracket as illustrated. (Page 11)

5.Before installing the lights, run the wires thru the large hole in the mounting plate. Insert the brown wire in the “Tail” position and the Yellow or Green in the “Turn” Position

6.Install the lights, right on the right side, left on left. Under one mounting stud install the Ring terminal with the white wire. This will ground the light directly.

7.Use Wire Ties provided to tie the harness to the fender and splitter as needed

Amber Reflector

Each Side

Part No. 10031

Yellow &	Green &
Brown Wire	Brown Wire
Light Left Hand	Light Right Hand
(486) 10028	(485) 10027