Outer Spool
Spring
Inner Reel
Figure 19
Indexing Teeth
Figure 20
Slotted Holes
For Use with |
| For Use with SplitLine or |
Single Line ONLY |
| Single Line |
|
|
|
Figure 21
Single Line Installation
Go To Step 8 for SplitLine™ Installation
6.Take approximately 25 feet (7.6 m) of new trim- ming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel. Pull the line through the inner reel so that the loop is as small as possible. See Figure 22.
7.Wind the lines in tight even layers, onto the reel. Wind the line in the direction indicated on the inner reel. Place your index finger between the two lines to stop the lines from overlapping. Do not overlap the ends of the line. See Figure 23. Proceed to step 11.
SplitLine™ Installation
8.Take approximately 12 feet (3.65 m) of new trim- ming line. Insert one end of the line through one of the two holes in the inner reel. Pull the line through the inner reel until only about 4 inches is left out. See Figure 24.
9.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible, See Figure 24.
10.Before winding, split the line back about 6 inches.
11.Wind the line in tight even layers in the direction indicated on the inner reel.
NOTE: Failure to wind the line in the direction indi- cated will cause the cutting attachment to operate incorrectly.
Loop
Figure 22
Figure 23
Loop
Figure 24
15