THROTTLE CONTROL ADJUSTMENT
If the throttle control requires adjustment or if it has been replaced and need adjustment, proceed as follows:
2.Push the throttle control lever on the handle all the way forward as far as it will go, then back it off one "click". Make certain the throttle control lever remains in this position.
3.Push the control lever on the engine as far toward the rear of the engine as it will go. Secure the cable in this position with the cable clamp and screw.
Screw
Cable
Clamp Control
Lever
Figure 12
1.Remove the screw shown in Figure 12. Remove the cable clamp from the cable.
NOTE: If you have a Tecumseh engine, simply loosen the screw so the cable will move freely beneath the clamp. It is not necessary to remove the screw and clamp completely.
CARBURETOR ADJUSTMENTS
WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), keep clear of all moving parts. Be careful of heated surfaces and muffler.
Minor carburetor adjustments may be required to compensate for differences in fuel, temperature, altitude and load. To adjust carburetor, refer to the separate engine manual packed with your mower.
NOTE: A dirty air cleaner will cause an engine to run rough. Be certain air cleaner is clean and attached to the carburetor before adjusting carburetor.
SECTION 8: MAINTENANCE
LUBRICATION
Lube
Lube
Lube
Lube
Figure 13
WARNING: Always stop engine and disconnect spark plug wire before cleaning, lubricating or doing any kind of work on lawn mower.
Blade Control
Lubricate the pivot points on the blade control handle and the brake cable at least once a season with light oil. See Figure 13. The blade control must operate freely in both directions.
Chute Deflector
Lubricate the torsion spring and pivot point periodically with light oil to prevent any rust or binding. Deflector must work freely.
Wheels
If your lawn mower has ball bearing wheels, lubricate at least once a season with light oil (or engine oil). Also, if the wheels are removed for any reason, lubricate the surface of the axle bolt and the inner surface of the wheel.
Engine
Follow engine manual for lubrication instructions.
13