Yard-Man 107 manual Assembling Your Lawn Mower

Page 7

SECTION 3: ASSEMBLING YOUR LAWN MOWER

To Remove Unit From Carton

•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.

•Remove loose parts included with your unit (i.e., operator’s manual, etc.).

•Cut along corners and lay carton down flat. Remove packing material.

•Roll or slide unit out of carton.

IMPORTANT: This unit is shipped WITHOUT GASOLINE. Make sure to service engine with gasoline and oil as instructed in the separate engine manual before operating your mower.

NOTE: Reference to right or left side of the mower is observed from the operating position.

Tools Required

Pair of pliers (not necessary, but helpful)

Disconnect Spark Plug Wire

•Disconnect spark plug wire from the spark plug and attach rubber boot to a bolt on the engine to ground. See Figure 1.

Rubber Boot

Spark Plug

Figure 1

Attaching Handle

•Pull up and back on the upper handle to raise the handle into the operating position. Make certain the lower handle is seated securely into the handle mounting brackets. Tighten the hand knobs on each side of the handle (carriage bolts and saddle washers must be seated properly into the handle as shown). See Figure 2.

NOTE: Your mower is shipped with the handle in the higher height position. If you wish to lower the height of the handle, refer to the instructions for handle height adjustment on page 10.

Carriage Bolt

 

 

 

 

Saddle

Upper

 

 

 

Washer

 

 

 

 

Handle

 

 

 

Lower

 

 

 

 

 

 

 

 

Handle

 

 

 

Hand

 

 

 

 

 

 

Knob

 

Saddle Washer

Figure 2

•Remove the hairpin clips from the outer holes in the weld pins on the handle mounting brackets.

•Using a pair of pliers, squeeze one leg of the lower handle against the handle mounting bracket. Insert the hairpin clip into the inner hole on the weld pin.

See Figure 3. Repeat on other side.

Hairpin

Clip in

Inner Hole

Weld

Pin

Lower

Handle

Handle

Mounting

Bracket

Figure 3

Attaching Starter Rope

•The rope guide is attached to the right side of the upper handle. Loosen the wing nut which secures the rope guide. For location of the wing nut, see Figure 4.

Insert starter rope into

 

rope guide

Wing Nut

 

Rope

Guide

Figure 4

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operator’s Manual Table of Contents General Operation Important Safe Operation PracticesSlope Operation ServiceChildren Your Responsibility Gaugesection 2 Slope Assembling Your Lawn Mower Converting to Side Discharge Know Your Lawn MowerOperating Your Lawn Mower Carburetor Handle HeightCutting Height Lubrication Maintaining Your Lawn MowerCutting Blade Engine Cutting DeckTrouble Possible Causes Corrective Action Trouble Shooting GuideParts List Model Ref. No Description ModelMANUFACTURER’S Limited Warranty for

107 specifications

The Yard-Man 107 is a robust outdoor equipment model that has garnered a reputation among gardening and landscaping enthusiasts for its reliability and efficiency. Designed with the consumer in mind, this machine delivers exceptional performance for both residential and commercial use.

One of the standout features of the Yard-Man 107 is its powerful engine. Typically equipped with a reliable four-stroke engine, it offers ample horsepower to tackle tough terrains and dense grass with ease. This power allows the mower to cut through thick vegetation, ensuring a clean and even finish every time. The machine's engine is also designed for fuel efficiency, reducing the frequency of refueling and lowering overall operational costs.

The cutting deck of the Yard-Man 107 is another impressive aspect. With a generous cutting width, it enables users to cover more ground in less time. The adjustable height settings provide versatility, allowing users to customize the cut according to the type of grass and the desired finish. This adaptability makes the Yard-Man 107 suitable for a variety of lawn conditions, from high and thick grass to well-manicured lawns.

Additionally, the Yard-Man 107 is integrated with advanced technologies that enhance its user-friendliness. Features such as self-propulsion enable operators to navigate difficult patches of grass effortlessly. The ergonomic design includes comfortable handles that reduce strain on the user, making long mowing sessions more manageable.

Safety is also a priority in the design of the Yard-Man 107. The mower is equipped with automatic shut-off functions that kick in if the operator releases the handle, preventing accidents and injuries. Furthermore, the construction of the mower includes durable materials that withstand harsh outdoor conditions, ensuring longevity and reliability.

In terms of maintenance, the Yard-Man 107 is designed for easy upkeep. Routine tasks such as changing the oil and sharpening the blades can be performed without specialist tools, which appeals to homeowners looking for convenience.

Overall, the Yard-Man 107 combines power, versatility, and safety, making it a preferred choice for lawn care enthusiasts. Its features and technologies not only enhance performance but also ensure a user-friendly experience, solidifying its place as a reliable tool in outdoor maintenance. Whether for a small backyard or a larger commercial property, the Yard-Man 107 is a commendable addition to any gardening toolkit.
Top Page Image Contents